A Barrett company - serving Arlington, TX

Tremron Home Additions & ADU in Arlington, TX

Home additions & ADUHome additions & ADU
Kitchen remodelingKitchen remodeling
Bathroom remodelingBathroom remodeling
RoofingRoofing
Windows & doorsWindows & doors
Driveway & paversDriveway & pavers
FenceFence
Every visit starts with

Free written scope consultation - allowances, timeline, and change-order rules on paper before a single trade is scheduled

We have financing partners for your dream remodel*On approved credit; ask us about your options
Get your free estimate

Tremron Home Additions & ADU: The Arlington Owner’s Guide

We build Tremron-compatible home additions and ADUs in Arlington, and a typical finished addition runs $45,000 to $130,000. We don’t do these same-day, because nobody should. What we do is put the whole scope, the allowance, and every line item in writing before a single nail moves, so the number you agree to is the number you pay.

Call (888) 590-9867

Owners usually come to us one of two ways. Either an older addition is failing at the seam where it meets the house, or a paver-clad patio or walkway around the new room has started heaving and settling after a Texas summer. Both send people looking for “the Tremron part.” Truth is, there usually isn’t a single failed part. It’s the substrate, the drainage, or the tie-in that gave out first, and that changes what the repair actually is.

Key takeaways:

  • This is planned construction, not an emergency repair. Expect a real schedule, not a same-day promise.
  • Tremron makes hardscape pavers and retaining wall systems. If your failing item is a paver, a wall block, or a cap, we can match and replace it. If it’s framing, roofing, or plumbing, that’s a different scope.
  • Every eligible addition gets permits pulled and inspections signed. In Arlington, that paper trail protects your resale value.

Which Tremron Models This Applies To

Tremron’s line splits into a few families, and matching the right block matters more than most homeowners expect. Their Olde English Wall and Mini Stonegate retaining wall systems work on a pin-and-slot interlock, while their Stonegate and Colonial lines use different heights and cap profiles. If someone replaced a block a few years ago with whatever was closest at the yard, you may be looking at two incompatible systems stacked together. That’s a common failure point, and it’s why a wall leans.

For pavers, the Olde Towne, Suburban, and Bergerac lines each carry their own thickness and coverage-per-pallet spec. Tremron publishes those numbers, and we check them against your existing field before ordering. Pull a single loose unit and measure thickness, face dimensions, and the paver’s chamfer. Look for a stamp or casting mark on the underside. Then call Tremron’s own tech line with the series name and the color code, which is usually printed on the pallet banding if you still have a scrap of it.

On the OEM-vs-aftermarket question: for structural wall blocks, stay with the actual Tremron unit. A knockoff with the wrong setback angle can fail a retaining wall inspection, and an inspector has no reason to sign off on a wall built from mixed systems. For caps and cosmetic pieces, a quality concrete equivalent is fine if the color and dimension match.

Barrett & Sons Construction Arlington is an independent builder. We’re not affiliated with Tremron. We install their products because they hold up, not because anyone sends us a check.

Explore

Styles & brands we work with

  • Kitchen remodeling
  • Bathroom remodeling
  • Home additions & ADU
  • Roofing
  • Windows & doors
  • Driveway & pavers
  • Fence

Signs Your Tremron Home Additions & ADU Is Failing

Five things we look for on an Arlington addition, in the order they usually show up:

  • Gaps at the seam where the addition meets the original house. That gap means the two structures are moving at different rates. Usually it’s a footing issue or a missing expansion joint, not a caulk problem, and caulk over it will just split again by the next hot summer.
  • Pavers heaving or sinking near the new room’s edge. Water is running toward the addition instead of away from it. Arlington’s clay-heavy soil swells and shrinks hard, so a base that wasn’t excavated deep enough will pump and settle within a couple of seasons.
  • Retaining wall blocks leaning or separating at the joints. Either the base course wasn’t compacted properly or the drainage behind the wall is clogged. Once the wall face moves out of plumb past a couple of degrees, it’s not getting better on its own.
  • Efflorescence, the white chalky bloom on concrete pavers. Some is normal in the first year. Heavy, recurring bloom means moisture is trapped in the base, often from a missing or blocked drainage layer.
  • Sticking doors or interior cracks near the addition. This points to foundation movement in the new section. It’s the one symptom that should stop you from repairing anything else until it’s diagnosed.
Before & after

See the difference

Before - Recent ProjectBeforeAfter - Recent ProjectAfter
Recent Project
Before - Full RestorationBeforeAfter - Full RestorationAfter
Full Restoration
Before - Complete UpgradeBeforeAfter - Complete UpgradeAfter
Complete Upgrade

Replacement Cost & What’s Included

Here’s how the numbers break down for Arlington, based on what we actually build:

Scope Typical Installed Range
Home addition (framing, foundation, tie-in) $45,000 – $130,000
ADU construction $90,000 – $220,000
Garage conversion to living space $30,000 – $80,000
Paver patio reinstatement around the addition $3,500 – $11,000
Paver driveway tied into the new scope $7,000 – $18,000

What drives the range? Foundation type, how much of the existing structure has to be removed and rebuilt, and the finish level you choose. Paver work is priced by square footage plus base prep, and base prep is where the money goes.

We give you a written line-item quote: materials, labor, disposal, permits, and inspections, each on its own line. Every allowance is on paper before work starts, because an allowance that isn’t on paper is a surprise waiting for a date. If the scope changes mid-job, it doesn’t happen until you sign a written change order. Every completed job carries our written 90-Day Done Right Promise: if it’s not right, Tom comes back and fixes it, one call.

DIY or Call Us?

Safe to check yourself: measure a loose paver or cap, look for the Tremron stamp or casting mark, photograph the loose joint, and note where water pools after a heavy rain. That’s information we want anyway, and it saves you a diagnostic visit.

Rebuilding a retaining wall or resetting pavers over a failing base is where DIY goes wrong. Not because it’s dangerous in the way electrical work is, but because the failure is almost always underground. Re-stacking blocks on a bad base just gives you the same lean back in a year. And any work near the addition’s foundation or tie-in should be looked at by someone who knows what foundation movement means, before you spend a weekend fixing the visible part and miss the real problem.

Call us at (888) 590-9867 and we’ll come out, tell you honestly what failed, and give you a free estimate. No pressure and no number thrown at you over the phone.

FAQs

Need Construction help nationwide? Licensed & insured · free written estimates
Call (888) 590-9867
Local Service Coverage

Request a Free Estimate in Arlington

Tell us what you need - Barrett & Sons Construction Arlington responds fast. No obligation.

By submitting this form you agree to our Privacy Policy and consent to be contacted by phone, email or SMS about your request, including by local professionals who may handle it.

Call Now - 24/7 Dispatch