Roofing
Kitchen remodeling
Bathroom remodeling
Home additions & ADU
Windows & doors
Driveway & pavers
FenceFree written scope consultation - allowances, timeline, and change-order rules on paper before a single trade is scheduled
Quikrete Roofing: The Arlington Owner’s Guide
Quikrete makes the patching and repair compounds that show up on a lot of Arlington roofs – not the shingle itself, but the roof cement, patch and coating products used to close around vents, chimney flashing and seams. When one of those repairs fails, you’re looking at $400-$1,800 for a roof repair in Arlington, and we can usually get eyes on it within a day or two of your call. Most owners find out the same way: a brown stain spreads across a ceiling, attic insulation goes damp after a storm, or a shingle edge starts flapping and you go up to look and the Quikrete patch under it has cracked loose.
Which Quikrete Models This Applies To
Quikrete sells roofing repair through a handful of product lines, and the label matters more than the shelf it came from. Roof Cement and Plastic Roof Cement come in 1-gallon cans and 10-ounce tubes; the plastic version holds up better on vertical surfaces because it doesn’t sag. Roof Patch in the tubs runs 1-quart to 4.5-gallon sizes. Then there’s the fibered asphalt coating and the elastomeric roof sealant, which behaves differently from the cement and gets used on different surfaces.
Here’s the gotcha most folks miss: the model number on a Quikrete roof cement can tells you the formula batch, not the application. Two cans from the same line can look identical and behave differently depending on whether they’re the fibered or non-fibered version. Read the product name, not the code. If your can is faded or the label is gone, a close-up photo of the failed area is what a pro actually needs to match the right product back in.
OEM-versus-aftermarket is a real decision here. Quikrete-brand cement from a store shelf is fine, but a roofing supplier’s mastic spec’d for the climate can outlast it. For a North Texas roof, the product that lasts is the one rated for the temperature swings, not the one with the best-looking label. We install Quikrete-compatible repair materials and match what’s already on the roof where it makes sense. Barrett & Sons Construction Arlington is an independent service provider and is not affiliated with Quikrete.
Styles & brands we work with
- Kitchen remodeling
- Bathroom remodeling
- Home additions & ADU
- Roofing
- Windows & doors
- Driveway & pavers
- Fence
Signs Your Quikrete Roofing Is Failing
Roof cement and patch fail in predictable ways once the sun and the freeze cycles get to them. Here’s what to look for:
- Cracking along the patched seam. The cement dries out and loses flexibility as it ages in the Texas heat. Once it cracks, water gets behind it and the failure accelerates.
- Soft or chalky texture when you touch it. A patch that’s gone rubbery-then-crumbly has broken down. That means the bond to the substrate is gone, even if it looks intact from a distance.
- Water stains on the ceiling below the patched area. The patch is letting moisture through at the edge, not the center. Water finds the seam, not the middle of the repair.
- Peeling or lifting tube-applied sealant around vents and flashing. Flashings move as the roof heats and cools, and a cured bead that’s lost adhesion will lift. This is the single most common source of a slow Arlington roof leak.
- Visible gaps where the patch meets shingles or metal. A gap smaller than a pencil width is enough. Shingle edges lift in summer heat and leave the sealant exposed.
See the difference
Before
After
Before
After
Before
AfterReplacement Cost & What’s Included
Roof repair in Arlington runs $400-$1,800 installed, and the Quikrete-matching part of that is modest – the materials are cheap. What drives the price is access, the height of the roof, whether the bad patch has to come off before a new one goes down, and whether the repair reveals damaged decking underneath. If the failure is structural and you’re looking at a full roof replacement, that’s $8,000-$20,000 in Arlington, but most Quikrete-type patch failures don’t get there.
What’s included with us: the failed patch removed and the substrate prepped, the correct product applied for the surface and the Texas climate, and the work backed by our written 90-Day Done Right Promise. Every price change – if decking needs replacing or a flashing turns out to be shot – comes to you as a written change order before anyone touches it. No surprise invoice at the end. The permit inspector works for you, not for us, so if the repair is one that needs a permit pulled, it gets pulled and signed.
DIY or Call Us?
You can safely walk your own roof to take photos, check for cracked cement or lifted sealant, and note where water is getting in. That’s useful and it’s free. But applying roof cement on a sloped surface 15 or 20 feet up is where owners get hurt, and a patch put on wrong just fails again in a year – you’ve spent an afternoon and added a fresh layer for the next guy to peel off.
We’re not going to tell you it’s impossible. We’re going to tell you the honest split: a ground-level inspection and a photo log, yes. The actual repair at height, no, unless you’re comfortable with ladders and know what product goes where. Our crew members have up to 28 years of experience with this exact kind of work, and Quikrete’s product line comes with an important reality – a repair product is only as good as the surface prep under it. Call (888) 590-9867 for a free estimate. We’re happy to look at photos you’ve taken and tell you what we see.
FAQs
Expect one to three years on a North Texas roof before the cement starts cracking, and less on a fully sun-exposed south slope. The heat and the freeze-thaw swings in Arlington tear through a dried-out cement film faster than a flexible elastomeric product would. When it goes, it goes on the seam first.
Yes, in most cases. If the substrate under the patch is sound, we can remove the failed cement, clean and prep the surface, and reapply the right product – which is a repair, not a replacement. If the decking underneath is wet or soft, that has to be addressed or the next patch will fail too.
A single patch repair is usually a half-day or less. If there are multiple failed patches, or the flashing needs attention, plan on a full day. We’ll tell you upfront what we expect so you’re not watching the clock.
We come up with the right Quikrete product or a spec’d equivalent for the surface, not whatever’s on the shelf. If you’ve already got a can with a readable label, we’ll use it – no need to buy a second one. We also handle KraftMaid, Cambria and Silestone on the remodeling side; roofing is what we do here.
If you’ve got a cracked patch, a wet ceiling, or a can of Quikrete cement sitting in the garage and you’re not sure where it goes, call (888) 590-9867 to schedule your free estimate. A live person answers the phone 24 hours a day, seven days a week, and Barrett & Sons Construction Arlington will give you a straight answer – free second opinion on any written estimate, $40 off any repair over $200, no trip charge inside the county, and a permanent 10% senior and veteran discount.
Written by the team at Barrett & Sons Construction Arlington, serving Arlington and nearby areas.