Driveway & pavers
Kitchen remodeling
Bathroom remodeling
Home additions & ADU
Roofing
Windows & doors
FenceFree written scope consultation - allowances, timeline, and change-order rules on paper before a single trade is scheduled
KraftMaid Driveway & Pavers: The Arlington Owner’s Guide
We don’t sell KraftMaid parts over a counter, but we do install the driveway and paver work that finishes a KraftMaid home, and paver driveway installation in Arlington typically runs $7,000 – $18,000 installed depending on square footage, base prep, and whether we’re replacing concrete or asphalt underneath. If your KraftMaid entry or driveway is failing, it’s usually the same story we hear across Arlington: masonry edges heaving after a wet spring, pavers rocking where the base wasn’t compacted, or a joint sand channel washing out toward the street. We come out, look at what’s actually under the surface, and tell you straight whether it’s a repair or a full replacement.
Key Takeaways
- KraftMaid doesn’t manufacture pavers or driveways – the “KraftMaid driveway” question almost always means the hardscape package around a KraftMaid-built home or addition.
- Arlington clay soil and summer heat cycles are the two biggest causes of paver failure here, not the pavers themselves.
- Paver driveway installation runs $7,000 – $18,000; concrete replacement runs $4,500 – $12,000.
- Every price change is a written change order before work starts. No surprise invoices at the end.
Which KraftMaid Models This Applies To
KraftMaid makes cabinetry, not pavers. That’s the honest first thing to say. If you’re searching for “KraftMaid driveway and pavers,” you’re almost certainly matching the hardscape to a KraftMaid kitchen or bath project – a home addition, a garage conversion, or an ADU where the driveway and entry approach are part of the finished exterior. The KraftMaid products we see paired with hardscape work most often are from the Delafield and Hanover lines, and the way to identify what you’re matching isn’t a paver label – it’s the finish and exterior trim palette on the home. Pull out your KraftMaid cabinetry spec sheet if you have it; the finish codes (Honey Spice, Dove White, Canvas, and the like) tell us more about the whole-house palette than any driveway document will.
On the paver side, the brands we actually install are Belgard and Techo-Bloc. Both publish full spec sheets – dimensions, compressive strength, freeze-thaw ratings – that you can look up before you sign anything. When a paver fails, the fix starts with a measurement: pulling a failed unit, matching the exact nominal size and thickness, and confirming the manufacturer’s batch. Older driveways within Arlington often have a 60mm paver that a newer supplier now runs at 50mm for the same nominal size, and the difference shows up as a trip edge within a year.
OEM versus aftermarket is a fair question, but for hardscape the practical version is this: match the paver brand and manufacturing plant when you can, and match the base spec exactly when you can’t. We install Belgard and Techo-Bloc because both have local supply in North Texas and both back their product lines with documented specs. Barrett & Sons Construction Arlington is an independent contractor and not affiliated with KraftMaid – we just know how their kitchens and baths pair with the hardscape work outside.
Styles & brands we work with
- Kitchen remodeling
- Bathroom remodeling
- Home additions & ADU
- Roofing
- Windows & doors
- Driveway & pavers
- Fence
Signs Your KraftMaid Driveway & Pavers Is Failing
Most Arlington owners discover a paver problem one of two ways: a wobble underfoot on the way to the mailbox, or a weed channel running across the driveway after a rain. Here’s what each of those usually means.
- Pavers rocking or “walking.” The bedding sand under the paver has shifted or washed out. Usually caused by insufficient base compaction or a missing edge restraint on the street side.
- Joint sand washing out after storms. The poly sand was either under-applied or installed in a way that never locked. In Arlington’s heavy spring rain band, unsealed joints fail within one season.
- Weed growth in joints, especially near the curb. Weeds follow water, and water follows a bad base. The weed is a symptom; the base is what we investigate.
- Heaving, dips, or a lip where the driveway meets the garage apron. Classic North Texas clay soil movement under a thin base. Fixing the paver without addressing the base just delays the return of the same dip.
- Spalling or chipped paver faces. Usually a freeze-thaw failure in a paver that wasn’t rated for the temperature swings we get in Tarrant County. Another reason we stick with brands that publish freeze-thaw specs.
See the difference
Before
After
Before
After
Before
AfterReplacement Cost & What’s Included
Here’s the pricing you’ll actually see from us in Arlington, installed. Nothing buried, nothing “plus materials.”
| Scope | Installed range |
|---|---|
| Paver driveway installation (full) | $7,000 – $18,000 |
| Concrete driveway installation | $4,500 – $12,000 |
| Asphalt driveway paving | $3,500 – $9,000 |
| Driveway replacement (tear-out and redo) | $5,000 – $14,000 |
| Driveway sealing | $250 – $700 |
| Paver patio installation | $3,500 – $11,000 |
What drives the range: the square footage, whether the existing surface has to come out, how deep the base needs to go (we’re often going 6 to 8 inches in Arlington to beat clay movement), the paver brand and style, and whether the edge restraint is being rebuilt. What’s included on every job: base prep, compaction, edge restraint, joint sand, cleanup, and a written scope of work before we start. Every price change after that is a written change order. Every completed job is covered by our 90-Day Done Right Promise – if something’s not right, one call brings Tom back out.
DIY or Call Us?
Here’s the honest split. What you can safely do yourself: walk the driveway and mark every rocking paver with chalk, photograph the joint sand after a hard rain to see where water’s running, check whether the edge restraint on the street side is intact, and confirm the base depth at one failed spot with a small shovel. That’s it. That’s the safe list.
What goes wrong when an owner takes it further: pulling up paver fields without measuring the base depth underneath, compacting over dry clay, re-locking joints without proper poly sand and a plate compactor, and reinstalling without an edge restraint on the downhill side. We’ve re-done those jobs in Arlington more times than we can count, and the bill is higher the second time because the base has to come out. A driveway is a load-bearing structure – if the base is suspect, it’s a job for trained crew members.
If it’s just sealing or re-sanding, that’s a fair question to price out. Driveway sealing in Arlington runs $250 – $700, and it’s often all a still-sound driveway needs. Call (888) 590-9867 and we’ll tell you honestly which side of the line your driveway is on – no upsell to a full replacement if a seal and re-sand will do the job.
FAQs
A properly installed paver driveway with a Belgard or Techo-Bloc product and a compacted 6-to-8-inch base typically lasts 25 to 30 years in Arlington. The pavers themselves often outlive the base work – when we see failure at 10 or 12 years, it’s almost always base depth or edge restraint, not the paver surface. Call (888) 590-9867 for a free look at what’s under yours.
Yes, often. Rocking pavers, washed-out joints, and localized dips can usually be repaired by lifting the affected field, re-compacting the base, resetting, and re-sanding – far cheaper than full replacement. What can’t be repaired in place is widespread base failure or a driveway that was never properly restrained on the street edge; those need tear-out. We give you a written estimate that spells out which one you’re looking at.
A typical 500 to 800 square foot paver driveway replacement in Arlington takes 3 to 5 working days: one to remove the existing surface and prep the base, one to two for base compaction and paver install, one for edge restraint and joint sand, one for cleanup and walkthrough. Concrete replacements finish faster, usually 2 to 3 days with cure. Permits are pulled and inspections signed on every job where the city requires them.
We source Belgard and Techo-Bloc through their local North Texas supplier network, and we start by identifying the exact brand, style, and manufacturing plant on your existing driveway – the spec sheet and batch code live on the supplier side once we narrow it down by measurement and color. You can look up any Belgard or Techo-Bloc product before you sign anything; that’s the point. If the original paver is discontinued, we’ll show you the closest match in dimension and color and let you decide. When your home also has KraftMaid cabinetry or nearby Cambria, Silestone, or Kohler finishes, we’re glad to talk through how the exterior palette ties in. Call (888) 590-9867 for a free second opinion on any written estimate – that offer’s on us.
Call (888) 590-9867 for a free estimate. A live person answers 24 hours a day, and we’ll walk the driveway with you, look at what’s under the pavers, and give you a written scope with real numbers before any work begins. Standing offers apply: $40 off any repair over $200, a free second opinion on any written estimate, no trip charge inside Tarrant County, and our permanent 10% Senior & Veteran discount.
Written by the team at Barrett & Sons Construction Arlington, serving Arlington and nearby areas.