Home additions & ADU
Kitchen remodeling
Bathroom remodeling
Roofing
Windows & doors
Driveway & pavers
FenceFree written scope consultation - allowances, timeline, and change-order rules on paper before a single trade is scheduled
Cambria Home Additions & ADU: The Arlington Owner’s Guide
If you’re planning a Cambria-topped addition or ADU in Arlington, budget $45,000 – $130,000 for a home addition and $90,000 – $220,000 for a full ADU, with quartz surfaces installed as part of the finish package. We pull the permits, schedule the inspections, and set the countertops so the seams land where they should. Most owners start down this road after a smaller job went sideways: a counter measured short, a slab cut before the wall framing was settled, or a contractor who said the permit was optional. That’s usually the moment they start asking who actually does this work in Arlington.
Cambria is a quartz surface brand, not an addition system, so the “part” here is the slab and the fabrication that goes on top of whatever you build. The failure shows up early – cracks at an inside corner, a seam that lifts after the first summer, or a slab that doesn’t fit a wall that moved two inches during framing. In Arlington, that last one is common on west-facing additions along the Rush Creek side of town, where afternoon sun hits the new exterior wall hard.
Which Cambria Models This Applies To
Cambria quartz comes in two thicknesses that matter for an addition: 2 cm (about 3/4 inch) and 3 cm (about 1-1/4 inch). Most kitchen islands and ADU counters across Arlington get 3 cm with a built-up edge for a heavier look; bathrooms and lower-traffic surfaces often go 2 cm. Cambria runs dozens of color lines and patterns, but the slab itself is not “model compatible” the way a garage door opener is – the compatibility question is thickness, edge profile, seam layout, and what your cabinet or island substrate can actually carry. A 3 cm slab weighs roughly 18 pounds per square foot, and an island top needs framing rated for that load plus whatever someone leans on it. Any label on the old slab or fabrication paperwork gives you the thickness and pattern; if there’s no paperwork, we measure the existing top and match it.
On the OEM-versus-aftermarket question, there’s no aftermarket equivalent to Cambria quartz worth considering. Cambria’s warranty follows the original fabrication and install, and a generic replacement slab breaks that chain. For a small kitchen or bath inside the addition, we also install Silestone quartz, KraftMaid cabinetry, and Kohler fixtures when a client wants a mixed-material approach, but the countertop warranty path stays cleanest with the same brand through the same fabrication line.
Styles & brands we work with
- Kitchen remodeling
- Bathroom remodeling
- Home additions & ADU
- Roofing
- Windows & doors
- Driveway & pavers
- Fence
Signs Your Cambria Home Additions & ADU Is Failing
- A hairline crack at an inside corner. Quartz doesn’t flex with the wood framing under it, so a corner that racks during the first dry Texas summer can crack. This usually traces back to a stiffener that was never added.
- A seam that lifts or darkens. Seams should be color-matched with an epoxy that stays tight. Lifting means the substrate is uneven or the epoxy was applied too thin – and once moisture gets in, it shows.
- Lippage where the counter meets the wall. If the new addition settled or the sheetrock was skimped, you’ll see a gap or a step. Poor framing under the slab, not the slab itself, is the usual cause.
- Chips at the sink or range cutout. Undersized cutouts or edges cut too thin leave quartz vulnerable at the weakest point. Once a chip reaches the edge, it’s hard to hide.
- Sun-fading or yellowing on a west wall. Cambria resists UV better than most stone, but heat cycling through a thin exterior wall can stress the bond between slab and substrate. If the surface looks off, the wall is the place to look.
See the difference
Before
After
Before
After
Before
AfterReplacement Cost & What’s Included
Replacing a Cambria top on an addition or ADU in Arlington runs with the project, so the honest answer is the whole-job scope: home addition $45,000 – $130,000, ADU construction $90,000 – $220,000, garage conversion $30,000 – $80,000. For a single countertop inside that build, countertop installation $2,000 – $6,500 and kitchen island installation $3,000 – $10,000 are the line items we quote. What moves you up the range: slab thickness, edge profile, number of seams, cutout complexity, and whether the substrate needs rebuilding first.
You get a written line-item quote before we touch anything, and every scope or allowance change comes to you as a written change order first – an allowance that isn’t on paper is a surprise waiting for a date. Permits are pulled and inspections signed on every eligible job. The work carries the 90-Day Done Right Promise in writing.
DIY or Call Us?
There’s no safe DIY path here, and I’d tell you the same over a fence. A 3 cm Cambria slab weighs hundreds of pounds, the cutouts need wet-cutting and edge finishing that a borrowed saw can’t do cleanly, and the substrate has to be built right before the slab goes on – get the framing wrong and you’ll crack a $2,000 slab the moment you set it. Quartz dust is also a silica hazard, which is why shops cut wet and wear respirators.
What you can safely do yourself: look at the old paperwork for the slab thickness and pattern, measure the top and the cabinet opening, take photos of any crack or lifted seam, and note where the seams run. That’s all we need to start. Call (888) 590-9867 – a live person answers 24/7 – and we’ll set up a free estimate. No trip charge inside the county, and we’ll give you a free second opinion on any written estimate you already have.
FAQs
How long does a Cambria countertop last on an addition or ADU? A properly fabricated and installed Cambria quartz top lasts 15 – 25 years or more in North Texas, and the surface itself is non-porous and doesn’t need sealing. Lifespan depends on the substrate and framing under it, not the slab – a shifted wall will shorten the life of any stone. If yours is cracking inside a decade, the install is the place to look. Call (888) 590-9867 for a free estimate on a fix.
Can it be repaired instead of replaced? Often, yes – a small chip or hairline crack can be repaired with color-matched epoxy, and it holds for years. A seam that’s lifted on a poorly built substrate usually needs the substrate fixed, not just the seam. We’ll tell you honestly which one you’re looking at. Call (888) 590-9867 for a free estimate either way.
How long does the swap take? A single countertop replacement takes 1 – 2 days once the slab is fabricated and the substrate is ready; a full addition or ADU is a months-long build with the countertop going in near the end. Fabrication lead time is the variable, not the install. Call (888) 590-9867 and we’ll give you a realistic timeline for your job.
How do you source the part? Cambria is a quartz brand, and we don’t keep inventory or parts on a truck – every slab is fabricated to the measured template by a shop we work with, then set on site. That’s the only honest way to do it, because a slab cut before the walls are settled is a slab that doesn’t fit. Call (888) 590-9867 to start with a free estimate.
Barrett & Sons Construction Arlington is an independent service provider and is not affiliated with Cambria. We’re owner-operated, founded in 1998, and proudly serving local communities for over 29 years. Our technicians have up to 28 years of experience. Every price change comes in writing before work moves, and calls are answered by a live person 24/7.
Ready to start your Arlington addition or ADU? Call (888) 590-9867 for a free estimate – $40 off any repair over $200, no trip charge inside the county, and a permanent 10% Senior & Veteran discount.
Written by the team at Barrett & Sons Construction Arlington, serving Arlington and nearby areas.