Driveway & pavers
Kitchen remodeling
Bathroom remodeling
Home additions & ADU
Roofing
Windows & doors
FenceFree written scope consultation - allowances, timeline, and change-order rules on paper before a single trade is scheduled
Delta Driveway & Pavers: The Arlington Owner’s Guide
If you’ve got a Delta hardscape product and something’s gone wrong, here’s the short version: we install and repair Delta paver driveways and patios in Arlington, a paver driveway typically runs $7,000 – $18,000 installed, a paver patio $3,500 – $11,000, and we can usually get eyes on it within days. We’re an independent contractor, not affiliated with Delta, but we know their lines well enough to match the right base, joint, and edge restraint to what you already have.
Most owners don’t discover a hardscape problem in one dramatic moment. It starts with a hairline crack by the garage apron that catches the mower wheel. Then a paver near the street starts rocking when you step on it. Then, after one Arlington summer of 100-degree days followed by a fall storm, the joint sand washes out and a couple of field units sit a quarter-inch proud of their neighbors. By the time you’re standing in the driveway scratching your head, the failure has usually been working for two or three seasons.
Which Delta Models This Applies To
Delta’s paver and driveway catalog runs across several families, and the one detail that trips up Arlington homeowners is that the same paver name can come in two thicknesses. The standard 60mm field unit is fine for a walkway or a patio under light foot traffic. A driveway – especially one that sees a full-size pickup or an RV – needs the 80mm (roughly 3 1/8-inch) unit, and many older Delta driveways in Arlington were laid with 60mm because that’s what was available or what the last installer had on hand. When a field unit starts to settle or crack under wheel load, thickness is the first thing to check, not pad compaction.
To identify what you have, pull one paver from an edge course (not the middle of a field) and measure its thickness with a caliper or a tape held dead flat. Delta molds also carry a subtle maker’s mark on the underside and a specific interlock profile – a tongue-and-groove or spacer-lug pattern that determines which paver will sit flush against its neighbor. Write those two things down: thickness and edge profile. That’s what any honest supplier or installer needs to match your existing stock.
OEM vs. Aftermarket for Delta
OEM replacement pavers give you an exact color-batch and interlock match, which matters most when you’re replacing five units in the middle of a visible field. Quality aftermarket units at the same spec (same thickness, same locking profile) work fine for edge courses, aprons, and any area where a slight color shift won’t bother you. Be honest with yourself about color fade: sun-faded Delta pavers in an Arlington driveway that’s seen a decade of UV will not perfectly match a fresh OEM unit out of the box. A good installer will blend new pavers into the field so the shift is invisible from the street.
Styles & brands we work with
- Kitchen remodeling
- Bathroom remodeling
- Home additions & ADU
- Roofing
- Windows & doors
- Driveway & pavers
- Fence
Signs Your Delta Driveway & Pavers Is Failing
Here’s what we actually see on Arlington properties, and what each symptom is quietly telling you.
- Rocking or “squishy” pavers when you walk on them. The base course under that paver has lost compaction or settled, usually from a drainage issue or inadequate sub-base prep. A rocking paver almost always signals a void underneath.
- Washed-out joint sand after every rain. Either the sand is the wrong grade (polymeric vs. plain), the base doesn’t drain, or water is channeling from a low spot toward the paver field. Sand loss accelerates fast in North Texas clay.
- Hairline cracks along an edge course or apron. Edge restraint has failed or was never pinned properly. Without it, the pavers creep outward and open up.
- Rutting where the tires sit. Vehicle load is exceeding what the base and paver thickness were built to carry. Common on driveways laid with 60mm units or an under-built base.
- Efflorescence – that white, chalky haze. Not a structural failure, but it means moisture is moving through the pavers from underneath. Left alone, moisture cycling through freeze-thaw and the hot-to-cool swing of an Arlington year will eventually loosen them.
See the difference
Before
After
Before
After
Before
AfterReplacement Cost & What’s Included
In Arlington, our installed pricing on Delta-compatible paver work looks like this:
| Service | Typical Installed Range |
|---|---|
| Paver driveway installation (full) | $7,000 – $18,000 |
| Paver patio installation | $3,500 – $11,000 |
| Partial paver replacement / repair section | Quoted against the repair |
| Driveway replacement (removing and re-laying base + pavers) | $5,000 – $14,000 |
What drives the range: driveway square footage, whether the base course needs full excavation or just re-compaction, thickness of paver (60mm vs. 80mm), edge restraint condition, and drainage. We write the scope, the allowance for pavers, and any change order before a single nail moves. If the base turns out worse than expected once we open it up, you get a written change order before we spend another dollar. Every job carries our written 90-Day Done Right Promise.
DIY or Call Us?
Honest split. What you can safely do yourself: measure the paver thickness, note the interlock profile, photograph the failed section, check whether joint sand is polymeric or plain, and clear any obvious debris from a drainage swale. That’s diagnostic work and it will save you money when you call.
Where DIY goes wrong: re-laying a paver field without proper compaction equipment. A hand tamper won’t do what a plate compactor does, and a paver that looks tight in June will be rocking by the next spring. Adding polymeric sand to a wet joint can seal in moisture and make efflorescence worse. And if the underlying base is failing, replacing pavers without fixing the base just puts good money on top of a bad foundation. Call Barrett & Sons at (888) 590-9867 for a free estimate – we’ll tell you honestly whether a spot repair or a full re-lay is the right call for your Delta driveway.
FAQs
How long should Delta pavers last in Arlington weather? A properly installed Delta paver driveway with an 80mm unit and a well-compacted base should hold 25 – 30 years or more, but the base and edge restraint matter more than the paver itself in North Texas clay. Most of what we replace in Arlington still has perfectly good pavers – it’s the base and edge restraint that quit first.
Can the paver be repaired instead of replaced? Often, yes. If the issue is localized to a few rocking pavers or a failed edge course, a spot repair with the right-match paver and re-compaction will hold. We’ll tell you up front when a repair is honest and when it’s just delaying a re-lay. Call (888) 590-9867 for a free estimate.
How long does a driveway or patio replacement take? A paver patio typically runs 2 – 4 days; a full driveway re-lay runs 4 – 7 days depending on base excavation and weather. We schedule around Arlington rain days rather than trying to force the job through a downpour.
How do you source Delta-compatible pavers? We order from suppliers who carry the current Delta interlock profiles and color batches, and we bring a physical sample to the site before installing so you can see the color against your existing pavers in your actual sunlight. That’s the only way to confirm the match before a single unit goes down. For related premium-brand work we also handle KraftMaid, Cambria, and Silestone.
Barrett & Sons Construction has been owner-operated since 1998 – Tom Barrett and his sons are on-site most days, not a call-center dispatching strangers. Every eligible job gets permits pulled and inspections signed. Call (888) 590-9867 for a free estimate on your Delta driveway or paver repair – we answer live, 24 hours a day. Ask about our $40 Off Any Repair Over $200, Free Second Opinion on Any Written Estimate, No Trip Charge Inside the County, and our permanent 10% Senior & Veteran discount.
Written by the team at Barrett & Sons Construction Arlington, serving Arlington and nearby areas.