A Barrett company - serving Arlington, TX

PGT Driveway & Pavers in Arlington, TX

Driveway & paversDriveway & pavers
Kitchen remodelingKitchen remodeling
Bathroom remodelingBathroom remodeling
Home additions & ADUHome additions & ADU
RoofingRoofing
Windows & doorsWindows & doors
FenceFence
Every visit starts with

Free written scope consultation - allowances, timeline, and change-order rules on paper before a single trade is scheduled

We have financing partners for your dream remodel*On approved credit; ask us about your options
Get your free estimate

PGT Driveway & Pavers: The Arlington Owner’s Guide

If you have PGT-brand pavers, retaining wall block or driveway edging on an Arlington property, we install and repair them, and a typical paver driveway installation here runs $7,000 – $18,000. Repairing or resetting a failed section is usually a smaller job and we price it in writing before anything moves. Most owners find out something’s wrong the same way: a paver lifts after a hard rain, a joint line wanders, or the edge restraint lets go and the whole field starts creeping toward the street. PGT makes a solid unit. What fails underneath it is almost always the base, the drainage, or the way it was laid.

Call (888) 590-9867

Key Takeaways

  • PGT paver driveways in Arlington typically cost $7,000 – $18,000 installed; repairs are quoted separately.
  • Most PGT paver failures we see in Arlington trace to base prep and drainage, not the paver itself.
  • We’re an independent contractor and not affiliated with PGT. We source the right PGT profile to match what’s already there.
  • You get a written line-item quote, permits pulled where required, and the 90-Day Done Right Promise.

Which PGT Models This Applies To

PGT sells pavers and hardscape units in several profiles, and matching is where most homeowners get lost. The common ones we see on Arlington driveways are the standard 4×8 and 4×9 paver, the larger 6×9 and 6×12 formats, and the tumbled or chamfered edge styles that show up on driveways in older neighborhoods. Each profile has its own nominal thickness, usually 2 3/8 inches for a driveway-grade unit versus 1 5/8 inches for a patio-only paver, and the thickness matters. Putting a thin patio paver in a driveway that takes vehicle load is a shortcut that shows up as cracking within a couple of seasons.

To identify what you have, pull one loose paver from a corner or a popped joint and measure length, width and thickness with a tape. Look for a stamp or mark on the underside; PGT units often carry one. That measurement is what a supplier matches against, and it’s what we ask before we quote.

On the OEM-versus-aftermarket question: PGT pavers rarely need “OEM” replacement because the unit itself is a commodity concrete product. What matters is matching dimension, thickness and color blend so a repair doesn’t read as a patch. Aftermarket units from a quality supplier are fine as long as the spec matches. We source the closest profile and blend, and we tell you upfront when an exact color match isn’t available so you can decide before we order.

Explore

Styles & brands we work with

  • Kitchen remodeling
  • Bathroom remodeling
  • Home additions & ADU
  • Roofing
  • Windows & doors
  • Driveway & pavers
  • Fence

Signs Your PGT Driveway & Pavers Is Failing

Here’s what we actually see on Arlington driveways when a PGT installation starts going bad, and what’s usually behind it.

  • Pavers rocking or sinking in a low spot. That’s base failure. Water got under the units and washed out or compacted the gravel, and the paver is just following the hole.
  • Weeds or grass pushing up through joints. Usually a sign the polymeric sand has broken down or was never fully set, letting moisture and seed into the joint sand.
  • Edges spreading toward the street or yard. The edge restraint has failed or was never set in enough concrete. Once the border lets go, the field creeps.
  • Ponding water after a storm. Arlington’s clay soil holds water, and a driveway graded flat or pitched toward the house will pool. That’s a drainage problem, not a paver problem.
  • Cracked or chipped units near the apron. Vehicle load on a thin paver or a base that wasn’t compacted to spec, especially where tires turn and scrub the surface.

One thing worth knowing: North Texas clay expands and contracts with the wet-dry cycle, and it’s unforgiving on a shallow base. A driveway built with 4 inches of compacted base in Arlington will move more than the same driveway on sand. We spec deeper base and better drainage here for that reason.

Before & after

See the difference

Before - Recent ProjectBeforeAfter - Recent ProjectAfter
Recent Project
Before - Full RestorationBeforeAfter - Full RestorationAfter
Full Restoration
Before - Complete UpgradeBeforeAfter - Complete UpgradeAfter
Complete Upgrade

Replacement Cost & What’s Included

Here’s what these jobs run in Arlington, installed, with base prep, edge restraint, and joint sand included:

  • Paver driveway installation: $7,000 – $18,000
  • Paver patio installation: $3,500 – $11,000
  • Concrete driveway installation: $4,500 – $12,000
  • Asphalt driveway paving: $3,500 – $9,000
  • Driveway replacement: $5,000 – $14,000
  • Driveway sealing: $250 – $700

The range moves on square footage, base depth, how much old material has to come out, drainage corrections, and whether you’re doing a full replacement or a section repair. Every line is itemized in writing before we start, and if the scope changes once we’re digging, you get a written change order before any work proceeds. Materials are named brands you can look up. The finished work carries the 90-Day Done Right Promise in writing on the contract: if something isn’t right, one call brings Tom back to fix it.

DIY or Call Us?

A homeowner can safely do a few things here. Pull a loose paver and measure it for a match. Sweep sand back into joints and re-settle a single unit with a rubber mallet. Clear weeds and check that downspouts and gutters aren’t dumping water onto the driveway.

Where it goes wrong: resetting a section without fixing the base underneath. A paver re-bedded on a washed-out base will rock again by the next rain, and you’ve spent the weekend twice. Rebuilding an edge restraint and correcting grade so water runs away from the house is where we earn our keep, because a bad slope sends water into your foundation or your garage. If more than a handful of units are moving, or water is pooling near the house, get eyes on it. Call (888) 590-9867 and we’ll take a look, quote it in writing, and tell you honestly whether it’s a repair or a rebuild.

FAQs

Need Construction help nationwide? Licensed & insured · free written estimates
Call (888) 590-9867
Local Service Coverage

Request a Free Estimate in Arlington

Tell us what you need - Barrett & Sons Construction Arlington responds fast. No obligation.

By submitting this form you agree to our Privacy Policy and consent to be contacted by phone, email or SMS about your request, including by local professionals who may handle it.

Call Now - 24/7 Dispatch