Driveway & pavers
Kitchen remodeling
Bathroom remodeling
Home additions & ADU
Roofing
Windows & doors
FenceFree written scope consultation - allowances, timeline, and change-order rules on paper before a single trade is scheduled
ES Windows Driveway & Pavers: The Arlington Owner’s Guide
We install and rebuild ES Windows-compatible driveway and paver systems for Arlington homeowners, and typical installed pricing runs $7,000 – $18,000 for a full paver driveway, $4,500 – $12,000 for concrete, $3,500 – $9,000 for asphalt paving, and $3,500 – $11,000 for a paver patio. Most Arlington owners first notice a problem the same way: a paver edge settles and holds water after a storm, a corner lifts under a tire, or the joint sand washes out every spring along the driveway apron. The driveway still works, but the finished system around it – the ES Windows assembly, the setting bed, the base – has started to let go.
Key Takeaways
- ES Windows driveway and paver components can be matched to your unit by model line and measurement, not guesswork.
- Installed pricing in Arlington runs $7,000 – $18,000 for pavers and $4,500 – $12,000 for concrete.
- We’re an independent service provider, not affiliated with ES Windows.
- Estimates are free, written, and priced line-by-line before any work starts.
Which ES Windows Models This Applies To
ES Windows has produced several hardscape-adjacent assembly lines over the years, and the part you need depends on which one is stamped on your unit. Before you buy anything, pull the model label from the frame or the stamped plate on the edge cap. If it’s worn off, measure the opening or paver footprint in inches – most ES Windows assemblies fit within a specific tolerance band, and a tape measure will usually tell you which generation you’re dealing with. We see a lot of units from the mid-2000s and early 2010s lines where the fastener spacing changed between runs, and that’s the gotcha: the part looks identical on the shelf but the anchor points won’t line up.
The OEM-versus-aftermarket call for ES Windows is real. Original parts carry exact dimensional match, but availability depends on the line and the model year. A quality aftermarket equivalent – when the spec matches – is often the more practical answer for a 10-plus-year-old assembly. We don’t carry parts in stock and we don’t claim a warehouse; we source the correct part for your ES Windows model and quote it before we order. KraftMaid, Cambria, and Silestone parts we also service, but for hardscape assemblies, ES Windows is the line we work with most in Arlington.
Styles & brands we work with
- Kitchen remodeling
- Bathroom remodeling
- Home additions & ADU
- Roofing
- Windows & doors
- Driveway & pavers
- Fence
Signs Your ES Windows Driveway & Pavers Is Failing
- Edge settling at the apron. The base under the ES Windows edge has compacted unevenly, usually after a wet Texas spring. You’ll see a dip at the transition where water pools.
- Lifted paver at the tire track. One unit is riding higher than the rest. That’s a failed setting bed or a joint that lost its lock, not cosmetic.
- Joint sand washing out every season. A chronic washout points to drainage running toward the assembly instead of away from it. The part isn’t the problem – the grade is.
- Cracks radiating from the corner anchors. Stress concentrated at the ES Windows mounting points over years of vehicle loading. Once it starts, patching won’t stop it.
- Visible freeze-line heave or sun-faded finish. Arlington’s summer heat and winter freezes are hard on sealants and finishes. Chalking and fading are early warnings the surface protection is gone.
Replacement Cost & What’s Included
Installed pricing in Arlington depends on the scope. A paver driveway runs $7,000 – $18,000. Concrete comes in at $4,500 – $12,000. Asphalt paving is $3,500 – $9,000, a full driveway replacement is $5,000 – $14,000, and a paver patio is $3,500 – $11,000. Sealing alone runs $250 – $700. What drives the range: base depth and compaction, removal and hauling, drainage correction, part sourcing for the ES Windows assembly, and finish selection. Every one of those lines is priced in writing before work starts.
Parts and labor are quoted separately so you can see what the ES Windows component costs versus the install. If your scope changes mid-job, the change order is on paper before we proceed – no surprises on the back end. Every eligible job includes permits pulled and inspections signed, and the finished work is backed by our written 90-Day Done Right Promise. Our crew members have up to 28 years of experience on hardscape and assembly work.
See the difference
Before
After
Before
After
Before
AfterDIY or Call Us?
An Arlington owner can safely do a few things: check the model label on your ES Windows unit, measure the footprint, photograph the failed section, and clean the joints. That’s a good picture to have before you call.
Where DIY goes wrong is at the base and the anchors. Under a paver or concrete surface, there’s a compacted base and a set of load-bearing anchors holding the ES Windows assembly in place. Get the compaction wrong on Arlington’s clay-heavy soil and the whole system fails again within a season. Get the anchor spacing wrong and you can crack the unit you just installed. This is heavy, edge-loaded material – not a weekend YouTube job if you want the result to last. When the part fails, the honest advice is to have the base and assembly evaluated before you buy a single paver. Call (888) 590-9867 and we’ll tell you what we actually see.
FAQs
Expect 15 – 25 years for well-installed pavers and 20 – 30 for concrete, but Arlington’s clay soil and summer heat cut that short if the base wasn’t compacted right. Sinking edges and washout are the early signs it’s aging faster than it should. Call (888) 590-9867 for a free condition check.
Often, yes – a single failed paver section or one joint washout is a repair, not a replacement, and repairs over $200 qualify for $40 off. Once cracks radiate from the anchors or the base has moved, replacement is the only fix that lasts. We’ll give you a written scope either way. Call (888) 590-9867.
A single-part repair is a one-day job; a full paver or concrete replacement runs 3 – 7 days depending on square footage and drainage work. Weather and inspection scheduling in Arlington can add a day or two. Call (888) 590-9867 and we’ll give you a written timeline with your estimate.
We start with your model label and actual measurements, then match the part to your specific ES Windows line and generation. If the OEM part isn’t available, we quote a spec-matched aftermarket equivalent and show you the difference on paper. Call (888) 590-9867 to start the match.
Get a Free Written Estimate in Arlington
If your ES Windows driveway or paver assembly has started to fail, call Barrett & Sons Construction Arlington at (888) 590-9867 for a free estimate. We’re owner-operated, every change gets a written change order before work starts, and the finished job is backed by the 90-Day Done Right Promise. Ask about the free second opinion on any written estimate, no trip charge inside the county, and the permanent 10% senior and veteran discount. A live person answers the phone.
Written by the team at Barrett & Sons Construction Arlington, serving Arlington and nearby areas.