Driveway & pavers
Kitchen remodeling
Bathroom remodeling
Home additions & ADU
Roofing
Windows & doors
FenceFree written scope consultation - allowances, timeline, and change-order rules on paper before a single trade is scheduled
ActiveYards Driveway & Pavers: The Arlington Owner’s Guide
We install ActiveYards driveway and paver systems in Arlington, and a full paver driveway typically runs $7,000 – $18,000 installed, with patio work at $3,500 – $11,000. This is planned work, not emergency work – we schedule it properly and pull the right permits. Owners usually find the failure the same way: a course of pavers near the driveway apron shifts after a heavy rain, a joint line sinks an inch below the rest, or a corner paver rocks underfoot and pumps muddy water when it’s stepped on.
Key Takeaways
- ActiveYards pavers are a manufactured hardscape product, matched by profile, thickness, and color line – not by a single universal part number.
- North Texas clay soil and summer heat cycling drive most failures we see in Arlington, not bad material.
- Replacement and re-lay work is quoted in writing before anything moves, backed by our 90-Day Done Right Promise.
- A live person answers the phone at (888) 590-9867, day or night.
Which ActiveYards Models This Applies To
ActiveYards isn’t one product line – it’s a family of manufactured hardscape brands under one banner, and the paver profile you have determines the replacement piece. The three families we run into most on Arlington driveways and patios are the structural slab pavers, the thinner profile pavers for walkways and borders, and the tumbled or textured face lines used on decorative aprons. Each comes in a specific face size and thickness, and a 60mm paver will not sit flush against a 50mm course without a visible lip. That lip is a trip point and a water trap.
Before you order anything, find the identifying information. Look on the underside of a loosened paver – many ActiveYards profiles are stamped. If there’s no stamp, measure three dimensions: length, width, and thickness to the millimeter. Photograph the face texture and the color under daylight, not under your garage light. A tan paver photographed in shade reads gray, and mismatched color is the single most common ordering mistake we correct.
On OEM versus aftermarket: the honest answer is that a quality aftermarket paver in the same dimensions and a close color match will perform identically once it’s bedded and jointed correctly. Where OEM matters is on a visible, high-traffic face where a color difference will bother you every time you pull in. We’ll tell you which situation you’re in. For kitchen and bath surfaces we carry KraftMaid, Cambria, and Silestone, and we hold the same standard on hardscape: materials you can look up, not mystery brands off a van.
Styles & brands we work with
- Kitchen remodeling
- Bathroom remodeling
- Home additions & ADU
- Roofing
- Windows & doors
- Driveway & pavers
- Fence
Signs Your ActiveYards Driveway & Pavers Is Failing
Most paver failures in Arlington read the same way once you know what you’re looking at. Here’s what the symptoms mean.
- Pavers rocking underfoot. The bedding sand has washed out or the base compacted unevenly. Once a paver rocks, the joint sand escapes with every step and the problem spreads outward from that point.
- Sunken joints or a low spot holding water. Underlying base failure, usually from clay soil that swelled after a wet spring and settled hard in August. Standing water in a joint line after rain means the base, not the paver, needs attention.
- Joint sand washing out after storms. North Texas downpours strip polymeric sand from a joint that was under-filled or installed in the wrong temperature window. Re-sanding a joint that never had enough depth is a temporary fix at best.
- Efflorescence – the white chalky haze. Mineral salts migrating to the surface. Sometimes it’s a curing artifact, sometimes it signals moisture trapped under the pavers because drainage is wrong. The distinction matters and it changes the repair.
- Chipped edges or corners on the driveway apron. Vehicle loads over a paver that’s lost its base support. A chipped apron paver is usually the visible symptom of a base problem two feet back.
See the difference
Before
After
Before
After
Before
AfterReplacement Cost & What’s Included
Here’s what the work costs in Arlington, using our standing ranges so you can budget before you call.
| Work | Installed Range |
|---|---|
| Paver driveway installation | $7,000 – $18,000 |
| Paver patio installation | $3,500 – $11,000 |
| Driveway replacement | $5,000 – $14,000 |
| Driveway sealing | $250 – $700 |
What moves the number: total square footage, how much base has to be excavated and re-compacted, whether the existing edge restraint can be reused, and whether the replacement pavers are an exact OEM match or a close aftermarket equivalent. Those are priced separately so you can see them.
Every quote is a written, line-item scope – pavers, base material, joint sand, edge restraint, labor, haul-away – issued before work starts. If a buried base problem turns up mid-job, that change arrives as a written change order before anybody touches it. An allowance that isn’t on paper is a surprise waiting for a date. Every eligible job gets permits pulled and inspections signed, and every finished job carries our 90-Day Done Right Promise: if it’s not right, Tom comes back and makes it right, one call.
DIY or Call Us?
Some of this you can check yourself, safely. Walk the driveway and mark rocking pavers with chalk. Measure your paver thickness. Photograph the face in daylight. Sweep joint sand back into low spots and see if it stays after the next rain. That’s the information a contractor needs anyway, and gathering it costs nothing.
Where owners get into trouble is the repair itself. Lifting a course of pavers to re-bed it sounds simple until you’re resetting a compacted base by hand in 100-degree heat, and a base that’s two inches too shallow will fail again within a season. Chasing a sinkhole by adding sand on top hides the problem and makes the next fix cost more. The real risk is doing the visible part right and the invisible part wrong – and the invisible part is where the money lives.
If you want a straight answer on whether your ActiveYards pavers need a re-lay or a full replacement, call (888) 590-9867. Estimates are free, a live person answers any hour, and there’s no trip charge inside the county. Ask about the free second opinion on any written estimate you’ve already got, and the permanent 10% senior and veteran discount while you’re at it.
FAQs
A properly installed ActiveYards paver driveway in Arlington should hold for 25 to 30 years or more, but the pavers themselves usually outlast the base under them. What ages first is the bedding sand, the joint sand, and the compaction of the base – especially on the heavy clay soil common across Tarrant County, which swells when wet and contracts hard in summer heat.
Yes, more often than not. Isolated rocking or sunken pavers can usually be lifted, the base re-compacted, and the same pieces re-bedded. Full replacement is the answer when the base failure runs across a whole section or the drainage grade is wrong. We won’t tell you it’s a full replacement if a repair will hold, and we put whichever one we recommend in writing.
A localized repair – a handful of pavers, re-bed and re-sand – is typically a one- or two-day job. A full paver driveway installation usually runs three to five days depending on square footage, base excavation, and weather. This is planned work, so we schedule it and give you a start date and a realistic finish, not a same-day promise nobody can keep.
We identify your profile by the stamp on the paver’s underside where one exists, and by measured length, width, and thickness to the millimeter where it doesn’t. From there we match the closest OEM or quality aftermarket piece and show you a physical sample before ordering, because color is the thing that goes wrong most often. We don’t stock parts and we don’t claim to – the right match is sourced per job for your ActiveYards line.
Barrett & Sons Construction Arlington is an independent service provider and is not affiliated with ActiveYards. We’re proud to serve local communities for over 29 years – founded in 1998, owner-operated from day one, with Tom Barrett and his sons on-site most days. Our technicians have up to 28 years of experience, every crew member is background-checked, and every job is backed by written change orders and the 90-Day Done Right Promise. Tom publishes his name, his address, and his license number – look it up before you sign anything. Ask anyone on your street, then call (888) 590-9867 to schedule your free estimate.
Written by the team at Barrett & Sons Construction Arlington, serving Arlington and nearby areas.