A Barrett company - serving Arlington, TX

Barrette Driveway & Pavers in Arlington, TX

Driveway & paversDriveway & pavers
Kitchen remodelingKitchen remodeling
Bathroom remodelingBathroom remodeling
Home additions & ADUHome additions & ADU
RoofingRoofing
Windows & doorsWindows & doors
FenceFence
Every visit starts with

Free written scope consultation - allowances, timeline, and change-order rules on paper before a single trade is scheduled

We have financing partners for your dream remodel*On approved credit; ask us about your options
Get your free estimate

Barrette Driveway & Pavers: The Arlington Owner’s Guide

We install and repair Barrette-brand driveway and paver systems across Arlington, and most full paver driveway projects run $7,000 – $18,000 installed, while repairs and localized resets land far lower. Barrette hardscape products are sold through dealer yards rather than stocked on any truck, so we source and confirm the exact match before we schedule the work. The homeowner usually finds the problem the same way: a settled corner by the garage apron, a paver that rocks underfoot after a rain, or a joint line that’s started wandering where the drive meets the street.

Call (888) 590-9867

Arlington sits on expansive clay soils that swell and shrink with every wet and dry cycle, and that movement is behind most of the driveway paver failures we see here. Add our summer heat cycling the surface and the picture gets clearer fast.

Key Takeaways

  • Barrette pavers and driveway components are dealer-sourced, so matching the series and color matters before any work starts.
  • Installed paver driveways in Arlington typically run $7,000 – $18,000; repairs cost far less.
  • Clay soil movement, not the paver itself, is the usual culprit behind settlement and rocking.
  • We’re an independent contractor, not affiliated with Barrette, and we tell you that upfront.
  • Every eligible job gets permits pulled and inspections signed, with work backed by the written 90-Day Done Right Promise.

Which Barrette Models This Applies To

Barrette Outdoor Living makes paver and hardscape lines plus the edge restraints, polymeric joint sand, and base components that hold a driveway together. The paver itself is the piece most homeowners think of, but on a failing Barrette drive the part that usually needs replacing is the edge restraint, the joint sand, or the compacted base under the field. Knowing which series you have is the starting point, because Barrette’s profile dimensions, thickness, and recommended joint width vary by line, and an edge restraint sized for one series won’t lock a different one in place.

To identify your part, look for the stamp or imprint on the face or edge of a paver, measure the actual length, width, and thickness with a tape (not the box label), and photograph the color and texture in daylight. If the original install paperwork exists, the series and color name will be on it. When it doesn’t, we match from the physical sample.

On the OEM-versus-aftermarket question: Barrette-brand components are worth matching when you’re repairing a visible field or keeping a color run consistent, since dye lots and profile edges drift between production batches. For hidden base and restraint work, a quality aftermarket equivalent that meets the same spec does the job and saves money. We’ll tell you which side of that line each part falls on. We’re an independent service provider and not affiliated with Barrette, so our recommendation is based on what fits and lasts, not on a brand obligation.

Explore

Styles & brands we work with

  • Kitchen remodeling
  • Bathroom remodeling
  • Home additions & ADU
  • Roofing
  • Windows & doors
  • Driveway & pavers
  • Fence

Signs Your Barrette Driveway & Pavers Is Failing

Paver driveways don’t fail overnight. They telegraph it, and if you catch the symptoms early you’re looking at a repair instead of a rebuild.

  • Pavers that rock or dip underfoot. That’s base settlement, usually where water has been getting under the surface through a failed joint or a low spot that ponds after a Texas downpour.
  • Joint sand washing out. Polymeric sand breaking down or eroding lets water into the base and lets weeds take hold; once the joints open, the whole system starts moving.
  • Edge restraint pulling away or lifting. The restraint at the driveway perimeter is what keeps the field from spreading. When it fails, pavers creep outward and gaps open along the street edge.
  • Wandering joint lines or a spreading pattern. Field pavers shifting out of alignment point to a base or restraint problem underneath, not a surface issue you can patch.
  • Cracks in individual pavers. Point-loading from an unsettled base, or roots and heaved soil beneath, will crack pavers from the underside up. A cracked paver is a symptom, not the disease.

In Arlington, we regularly see spring joint failures after the wet season loosens the base and the dry summer then pulls it tight again. That back-and-forth is hard on a driveway that wasn’t built with the right base depth and drainage to begin with.

Before & after

See the difference

Before - Recent ProjectBeforeAfter - Recent ProjectAfter
Recent Project
Before - Full RestorationBeforeAfter - Full RestorationAfter
Full Restoration
Before - Complete UpgradeBeforeAfter - Complete UpgradeAfter
Complete Upgrade

Replacement Cost & What’s Included

Here’s the honest ballpark for Barrette-compatible driveway and paver work in Arlington, parts and labor together:

  • Full paver driveway installation: $7,000 – $18,000
  • Paver driveway replacement: $5,000 – $14,000
  • Concrete driveway installation (if you’re comparing): $4,500 – $12,000
  • Asphalt driveway paving (if you’re comparing): $3,500 – $9,000
  • Driveway sealing: $250 – $700
  • Paver patio installation: $3,500 – $11,000

What drives the number up or down: driveway square footage, base depth needed to handle Arlington’s clay, removal and haul-off of the old surface, drainage corrections, and whether we’re matching an existing Barrette series or installing a fresh one. All of that gets spelled out in a line-item written estimate before any work starts, and every scope or allowance change comes to you as a written change order before we proceed. No surprise invoice at the end. The finished work is backed by our written 90-Day Done Right Promise.

DIY or Call Us?

Some things you can safely check yourself. Walk the drive and mark rocking pavers with chalk, hose it down and watch where water ponds, and look along the street edge for restraint gaps or pavers creeping outward. Snap a couple of photos. That’s useful information and it costs nothing.

What goes wrong with DIY on driveway pavers is almost always the base. Re-setting a paver into a hole you dug by hand feels like a fix, but without proper compaction in lifts and the right base material, the same spot settles again within a season, and sometimes worse the second time. Pulling an edge restraint to “tighten things up” without re-compacting and re-anchoring it lets the whole field spread. And re-sanding joints without fixing the water source underneath just resets the clock on the same failure. Nobody gets hurt here, but a lot of money gets spent twice.

We source the correct Barrette component, prep the base the way it should have been prepped, and stand behind the result. Call (888) 590-9867 and we’ll take a look.

FAQs

How long do Barrette driveway pavers last in Arlington? A properly installed paver driveway will typically give you decades of service, but the real lifespan here comes down to the base and drainage, not the paver. In Arlington’s clay soil, a shallow or poorly drained base can start showing settlement within a few years, while a correctly built one holds up far longer. The pavers themselves outlast the installation underneath them.

Can my failing driveway be repaired instead of replaced? Often, yes. Localized settlement, a failing edge restraint, and washed-out joints are all repairable without tearing out the whole drive. The deciding factor is whether the base under the field is sound or whether the movement is widespread. We’ll tell you honestly which category you’re in, and we don’t upsell a full replacement when a targeted repair will do. Call (888) 590-9867 for a free estimate and a straight answer.

How long does the repair or swap take? A small reset or restraint repair is usually a short job, often wrapped up in a day. A joint re-sand with base correction runs longer depending on square footage, and a full driveway install is a multi-day project with the base and curing time factored in. We’ll give you a realistic timeline in writing with the estimate, not a guess on the phone.

How do you source the Barrette part? We match your series and color from a physical sample and the paver’s face stamp, then source the correct Barrette component through the dealer yard that carries that line. Because these are dealer-sourced rather than sitting on a shelf, we confirm the exact match and availability with you before we schedule, so there’s no showing up with the wrong profile or a color that doesn’t blend.

For driveway and paver work at your Arlington home, we’ll walk the property, match the part, and hand you a written line-item estimate you can actually read. Our crews also install KraftMaid, Cambria, and Silestone on the interior side when a project runs from the curb to the kitchen. Call (888) 590-9867 for a free estimate – a live person answers around the clock, and we’ll get you the honest number before anyone touches a paver.

Written by the team at Barrett & Sons Construction Arlington, serving Arlington and nearby areas.

Need Construction help nationwide? Licensed & insured · free written estimates
Call (888) 590-9867
Local Service Coverage

Request a Free Estimate in Arlington

Tell us what you need - Barrett & Sons Construction Arlington responds fast. No obligation.

By submitting this form you agree to our Privacy Policy and consent to be contacted by phone, email or SMS about your request, including by local professionals who may handle it.

Call Now - 24/7 Dispatch