A Barrett company - serving Arlington, TX

Belgard Driveway & Pavers in Arlington, TX

Driveway & paversDriveway & pavers
Kitchen remodelingKitchen remodeling
Bathroom remodelingBathroom remodeling
Home additions & ADUHome additions & ADU
RoofingRoofing
Windows & doorsWindows & doors
FenceFence
Every visit starts with

Free written scope consultation - allowances, timeline, and change-order rules on paper before a single trade is scheduled

We have financing partners for your dream remodel*On approved credit; ask us about your options
Get your free estimate

Belgard Driveway & Pavers: The Arlington Owner’s Guide

We install Belgard pavers for Arlington driveways, and a paver driveway here typically runs $7,000 to $18,000 installed, depending on square footage, base prep and whether an old slab has to come out first. Most Arlington homeowners find out something is wrong when a paver rocks underfoot after a rain, when sand starts washing to the curb, or when a hairline crack opens along a joint and keeps coming back no matter how many times it gets filled.

Call (888) 590-9867

Belgard makes the pavers, not the base under them. That distinction matters because in our experience, nine out of ten “Belgard problems” in Arlington are installation problems: shallow base, a driveway poured too close to the slab, drainage running back toward the house. We’re an independent contractor and not affiliated with Belgard, so we can tell you plainly which problem is the product and which is the ground beneath it.

Key Takeaways

  • Belgard paver driveways in Arlington run $7,000 to $18,000 installed.
  • Most failures are base and drainage problems, not failed pavers.
  • Individual pavers can be lifted and reset without tearing out the whole driveway.
  • We pull permits and sign inspections on eligible work, and every job carries our 90-Day Done Right Promise.

Which Belgard Models This Applies To

Belgard sells paver driveways through a handful of product families, and knowing which one you have tells us how to reset or match it. The three Arlington homeowners most often have are Aqualine (permeable, open-joint), Urbana Stone and Mega-Lafitt (the larger-format structural pavers used on driveways), and the older Dublin Cobble and Cambridge Cobble lines that show up on homes built here in the 1990s and 2000s.

The fastest way to identify yours is the joint pattern. Aqualine and other permeable systems sit on wider joints filled with open-graded aggregate, while a standard structural paver on a sand-bed joint sets tight with polymeric sand. If the original installer left a spare bundle in the garage or shed, the wrapper tells you the series, the color and the factory SKU. Without that, we measure length, width and thickness with a caliper and match against manufacturer specs. A full-size Mega-Lafitt is roughly 2 3/8 inches thick, the standard the base has to be built to carry. That thickness and the base depth are what the next owner inherits, so getting the model right matters for resetting a single paver and for a full replacement later.

OEM Belgard pavers are the answer for anything visible. Color lots shift from one production run to the next, and a generic big-box paver will not match a three-year-old Belgard field, even in the same color name. We source genuineBelgard product for visible repairs and note honestly that color-batch matching is never exact. Where the part is invisible (base aggregate, geotextile fabric, polymeric sand), a quality equivalent is fine.

Explore

Styles & brands we work with

  • Kitchen remodeling
  • Bathroom remodeling
  • Home additions & ADU
  • Roofing
  • Windows & doors
  • Driveway & pavers
  • Fence

Signs Your Belgard Driveway & Pavers Is Failing

  • Pavers rocking underfoot after a rain. The bedding sand under that paver has washed out or the base was never compacted to depth. This is the warning sign, and a paver that rocks in spring moves toward failure by summer.
  • Sand washing to the curb or street. Either the joint sand was not topped off during the last rain, or water is running across the driveway because the slope wasn’t built to shed it. Both are drainage problems, not paver problems.
  • A joint that keeps cracking open after filling. Polymeric sand that fails this way was usually installed too wet, or over a joint that was never tight. Re-filling it without addressing the joint will produce the same crack in the same place.
  • Settling or a low spot where water pools. Base depth in Arlington’s clay soil is where this starts. Clay holds water, and a shallow base will move. The spot doesn’t fix itself.
  • Chips and broken corners along the driveway edge. Usually the edge restraint has failed and the pavers are spreading. The pavers themselves are fine; the edge is what needs attention.
Before & after

See the difference

Before - Recent ProjectBeforeAfter - Recent ProjectAfter
Recent Project
Before - Full RestorationBeforeAfter - Full RestorationAfter
Full Restoration
Before - Complete UpgradeBeforeAfter - Complete UpgradeAfter
Complete Upgrade

Replacement Cost & What’s Included

For Arlington, a paver driveway installed runs $7,000 to $18,000 with Belgard product and a properly built base. The range is driven by square footage, base depth, whether an old concrete slab is removed, and edge restraint. A single-paver reset is priced as a small repair, well under the full-install number. If the base is sound and only the surface needs work, sealing runs $250 to $700 and is the cheapest way to add years to a Belgard field.

Every quoted price is a written, line-item estimate: parts, base prep, sand, edge restraint, labor. If the job uncovers a base problem nobody could see, you get a written change order before we lift a paver. We pull permits and inspections where the work requires it, and every completed job is backed by our 90-Day Done Right Promise. If it’s not right, you call us and we come back.

DIY or Call Us?

There’s real value in what a homeowner can do safely: sweep back the joint sand and check for voids, note which pavers rock, check that downspouts aren’t dumping onto the driveway, and lift a single loose paver to see what’s underneath. Anyone can look. What goes wrong is the reset. A paver lifted and set back on uncompacted sand will rock again within a season, and the real fix (base, compaction, edge) is heavy work. On a driveway, a paver edge restraint failure that goes unaddressed spreads the field, and by the time it’s visible it’s a bigger job than it was.

If the paver is cracked, rocking or the joint has failed, call us at (888) 590-9867. We’ll look at it, tell you honestly whether it needs a reset or a new base, and give you a free estimate. No trip charge inside the county, and the free second-opinion offer stands on any written estimate you’ve already received.

FAQs

Need Construction help nationwide? Licensed & insured · free written estimates
Call (888) 590-9867
Local Service Coverage

Request a Free Estimate in Arlington

Tell us what you need - Barrett & Sons Construction Arlington responds fast. No obligation.

By submitting this form you agree to our Privacy Policy and consent to be contacted by phone, email or SMS about your request, including by local professionals who may handle it.

Call Now - 24/7 Dispatch