Driveway & pavers
Kitchen remodeling
Bathroom remodeling
Home additions & ADU
Roofing
Windows & doors
FenceFree written scope consultation - allowances, timeline, and change-order rules on paper before a single trade is scheduled
CertainTeed Driveway & Pavers: The Arlington Owner’s Guide
If your CertainTeed paver driveway in Arlington is losing joints, heaving at the edges, or showing cracked units after a hard freeze, the fix is usually a targeted repair or a partial re-lay, and installed projects in Arlington typically run $7,000 – $18,000 for a full paver driveway, with smaller repairs priced separately. We install and repair CertainTeed-compatible paver systems across Arlington and the surrounding county. Barrett & Sons Construction Arlington is an independent contractor, not affiliated with CertainTeed.
Most owners don’t notice the failure until winter. A joint opens, a corner lifts under the tire, or a 3-foot seam of sand washes out after summer rain and the pavers start rocking the next morning. By the time you feel it underfoot, the base has usually been moving for a season. That’s the picture we see most often on Arlington driveways built more than a decade ago: the surface did its job, but the bedding and edge restraint gave out first.
Which CertainTeed Models This Applies To
CertainTeed pavers land under several product families, and the ones we see on Arlington properties most often are concrete interlocking pavers sold in both 60mm and 80mm thickness, with 80mm reserved for driveways where vehicles sit and roll. The 60mm is fine for patios and walkways; using it under a car is where most premature failures start. If you’re identifying what you have, look at the underside of a lifted paver for a stamped manufacturer mark, then measure thickness with calipers. A 60mm paver will read about 2-3/8 inches; an 80mm reads about 3-1/8 inches.
The OEM-versus-aftermarket decision matters more in pavers than in most trades. CertainTeed colors and surface finishes shift slightly between production runs, so a mill-order match for a 5-year-old color will sometimes read a shade off in direct sun. Original-grade CertainTeed units are the right call for visible front-of-drive repairs. For hidden rear aprons or utility cut-ins, a matched aftermarket paver of the same thickness and base color is a defensible choice and often faster. We measure, spec, and order either way. We also work with KraftMaid, Cambria, and Silestone on interior projects, but the driveway line stays simple: thickness, color, and joint sand are the three details that decide whether the fix holds.
Styles & brands we work with
- Kitchen remodeling
- Bathroom remodeling
- Home additions & ADU
- Roofing
- Windows & doors
- Driveway & pavers
- Fence
Signs Your CertainTeed Driveway & Pavers Is Failing
- Paver rocking underfoot or under a tire. The bedding sand has washed out below, usually because the edge restraint let go or the base wasn’t compacted in lifts when it was built.
- Joint sand disappearing after rain. Polymeric sand that’s more than about five years old in Arlington’s summer heat loses binder and blows out, and once joints open, water gets underneath and the base softens.
- Heaving or a rise in one section. Typically tree roots, a drainage swale that points the wrong way, or expansive clay soil lifting under the edge. In Arlington, spring clay movement after a wet winter does this more than pavers themselves do.
- Cracked or chipped paver faces. Almost always a base failure under the paver, not the paver failing. Replacing the unit without fixing what’s under it just moves the problem one course over.
- Sunken spots near the garage apron or street. Heavy vehicles over a driveway that was built for cars, or a compacted-base failure at the transition. Both need excavation and re-lay, not a surface patch.
See the difference
Before
After
Before
After
Before
AfterReplacement Cost & What’s Included
For Arlington, a full paver driveway installation runs $7,000 – $18,000. Concrete driveway installation runs $4,500 – $12,000, asphalt paving runs $3,500 – $9,000, and a like-for-like driveway replacement runs $5,000 – $14,000. Driveway sealing, if that’s the fix, is $250 – $700. A paver patio installation runs $3,500 – $11,000. Those are installed prices, not material alone.
What drives the range: square footage, base depth (8-inch compacted base is common in Arlington clay; we sometimes spec deeper under a heavy-use apron), edge restraint type, polymeric sand, and whether existing pavers get dug and re-used or replaced entirely. Every scope, every allowance, every price change arrives as a written change order before work happens. No surprise invoices at the end. The job is backed by the written 90-Day Done Right Promise.
DIY or Call Us?
A homeowner can safely do three things: sweep polymeric sand into open joints each spring, check that the edge restraint is intact, and keep the driveway clear of standing water after a rain. Those are maintenance. They aren’t repairs.
Where DIY goes wrong with paver driveways is the base. Digging up one section, tamping it, and re-laying pavers without proper compaction in lifts, without the right aggregate, and without correct slope back to grade will look right for one season and fail the next. We’ve seen it on Arlington jobs the last contractor “fixed” the same way. It isn’t dangerous the way a garage-door spring is dangerous, but it’s expensive the second time around. If you can feel a rocker under your shoe, stop driving on it and call (888) 590-9867 for a free estimate. A live person answers, day or night.
FAQs
The pavers themselves typically last 25 to 30 years or longer when properly installed on a compacted base. What fails first is the joint sand and the bedding, not the unit. Re-sanding every 3 to 5 years in Arlington’s heat stretches the life of the whole system.
Yes, if the failure is localized. A single sunken section, a cracked paver, or a failed edge restraint can usually be dug, re-based, and re-laid for a fraction of replacement. If more than about a third of the drive is rocking, replacement is the honest answer. Call (888) 590-9867 for a free estimate and a straight read on which way it goes.
A small repair is often one day. A full paver driveway installation in Arlington typically runs three to five days depending on square footage, base prep, and weather. You’ll get a written timeline before we start, and any scope change arrives as a written change order first.
We measure the existing paver, identify the thickness and color family, and order from the manufacturer or an authorized supplier. We don’t claim stock on a truck or a warehouse of parts; what we do is spec the right paver, get it delivered, and install it. If the color is discontinued, we tell you before you commit, and lay out a mock panel so you can see the difference.
If you’re looking at a rocker in the drive or a joint that won’t stay put, the right next step is a free estimate. We’ll walk the driveway with you, tell you what’s actually failing, and put the scope in writing. Call Barry & Sons Construction Arlington at (888) 590-9867 to schedule your free estimate. Ask for the second opinion on your last contractor’s written quote, it’s free. Senior and veteran discount is 10%, and there’s no trip charge inside the county.
Written by the team at Barrett & Sons Construction Arlington, serving Arlington and nearby areas.