A Barrett company - serving Arlington, TX

CertainTeed Kitchen Remodeling in Arlington, TX

Kitchen remodelingKitchen remodeling
Bathroom remodelingBathroom remodeling
Home additions & ADUHome additions & ADU
RoofingRoofing
Windows & doorsWindows & doors
Driveway & paversDriveway & pavers
FenceFence
Every visit starts with

Free written scope consultation - allowances, timeline, and change-order rules on paper before a single trade is scheduled

We have financing partners for your dream remodel*On approved credit; ask us about your options
Get your free estimate

CertainTeed Kitchen Remodeling: The Arlington Owner’s Guide

CertainTeed doesn’t make kitchen cabinets or countertops. They make the drywall, insulation, and gypsum board that goes behind and above your kitchen, plus the fiber cement siding that sits outside the wall the kitchen backs up onto. When we install a kitchen in Arlington using CertainTeed materials, the full remodel runs $14,000 – $45,000 depending on cabinet count, countertop run, and whether the wall assemblies get opened. We are an independent contractor and not affiliated with CertainTeed.

Call (888) 590-9867

Owners usually discover a CertainTeed problem without knowing that’s what they’re looking at. A bulge under the kitchen window paint. A soft spot in the drywall above the range hood. Cracked paint lines radiating from the corner bead. Or moisture reading high on the exterior wall where a fiber cement panel’s caulk joint let go after a west-facing summer. In Arlington, those symptoms mostly show up on south and west elevations where the sun hits hardest from June through September.

Here’s what that means for your kitchen: CertainTeed board and siding failures don’t fix themselves, and they don’t stay inside the wall. They end up in the cabinet backs, the countertop substrate, and eventually the framing behind it.

Which CertainTeed Models This Applies To

CertainTeed’s kitchen-adjacent products break into two families. Inside the wall you have gypsum: the AirRenew line (moisture- and mold-resistant, common in kitchens and baths) and the standard Easi-Lite and Lite-Roc board sold throughout Texas. Outside, the kitchen wall is often clad in WeatherBoards fiber cement siding, the Monogram siding line, or the Restoration Millwork trim.

Identifying what you actually have takes one look. Pull a piece of base trim or a receptacle cover and check the paper face for a printed CertainTeed mark and a date stamp. WeatherBoards panels are stamped on the back face; AirRenew board carries a printed green stripe. If you can’t find a stamp, a magnet on the corner bead tells you whether the assembly was screwed or nailed, and a moisture meter reading above 18% on interior board near an exterior wall points to a siding-side leak rather than a plumbing issue.

The OEM-vs-aftermarket call is where CertainTeed differs from cabinet or hardware parts. Replacement WeatherBoards panel has to match the existing exposure, thickness (typically 5/16 or 7/16 inch), and finish texture, or the wall shows a seam and a color break that no paint will hide. For interior board, matching the exact product line matters less than matching the thickness and joint treatment. Our crew members have up to 28 years of experience and can usually identify the line by eye, but the stamp check is what we verify before ordering.

Explore

Styles & brands we work with

  • Kitchen remodeling
  • Bathroom remodeling
  • Home additions & ADU
  • Roofing
  • Windows & doors
  • Driveway & pavers
  • Fence

Signs Your CertainTeed Kitchen Remodeling Is Failing

  • Bubbling or blistering paint on the kitchen-side wall. Usually a moisture problem from the exterior siding’s caulk joint or a failed window flashing above the kitchen. The paint is telling you water is inside the assembly.
  • Cracked joints radiating from corners or above doorways. A CertainTeed drywall joint that cracked in a straight line means the framing behind it moved, or the board was hung tight against a corner with no gap. In Arlington’s expansive clay soil, foundation movement is the usual suspect.
  • Soft or crumbly board around the sink and range. Water and steam over years degrade standard gypsum. If it dents with a thumbnail, the board has taken on moisture and needs replacement, not patching.
  • Chalking or fading on the exterior wall the kitchen backs onto. WeatherBoards and Monogram siding will chalk in Texas sun. When it stops holding paint and starts powdering on your hand, the finish has reached the end of its service life.
  • Visible seams or fastener “telegraphing” on the kitchen ceiling. The drywall screw heads have pushed through the joint compound, or panel edges weren’t backed with framing. Common after attic temperature swings over an unvented kitchen.
Before & after

See the difference

Before - Recent ProjectBeforeAfter - Recent ProjectAfter
Recent Project
Before - Full RestorationBeforeAfter - Full RestorationAfter
Full Restoration
Before - Complete UpgradeBeforeAfter - Complete UpgradeAfter
Complete Upgrade

Replacement Cost & What’s Included

This isn’t a part swap in the traditional sense. When CertainTeed board or siding has failed inside your kitchen, the work ranges from opening and re-boarding a wall section to a full kitchen remodel with new assemblies. In Arlington, that’s $14,000 – $45,000 for a full kitchen scope, $9,000 – $20,000 for a small kitchen, and cabinet installation alone at $4,000 – $13,000. A targeted board repair or a single siding elevation is quoted separately.

What drives the range: how many wall assemblies get opened, whether the kitchen is gutted to studs or spot-repaired, cabinet count and layout, and whether countertop substrate has to come out. We install CertainTeed alongside KraftMaid cabinetry, Cambria and Silestone counters, and the rest of the trade-specific brands we carry.

Every scope, allowance, and price change arrives on your contract as a written change order before it happens. Permits get pulled and inspections signed on every eligible job. Everything we finish is covered by the 90-Day Done Right Promise in writing, and if something’s wrong, one call brings Tom back.

DIY or Call Us?

You can safely check a few things yourself. Look for the CertainTeed stamp on exposed board or siding. Run a $25 moisture meter across the wall behind the sink and under the window. Feel for soft spots. Photograph any caulk joint that’s opened up on the exterior kitchen wall. None of that involves opening a wall or getting on a ladder above head height.

What goes wrong in DIY: homeowners patch over moisture-damaged board instead of finding the source, and the new patch fails within a season. Siding work means ladders, wind, and a fall risk we don’t talk homeowners into. And if the kitchen wall is tied into structural framing or a load-bearing header, opening it without a permit leads to an inspection failure that costs more than the original job. If your CertainTeed wall or siding is failing, give us a call at (888) 590-9867 and we’ll look at it before anyone touches drywall.

FAQs

Need Construction help nationwide? Licensed & insured · free written estimates
Call (888) 590-9867
Local Service Coverage

Request a Free Estimate in Arlington

Tell us what you need - Barrett & Sons Construction Arlington responds fast. No obligation.

By submitting this form you agree to our Privacy Policy and consent to be contacted by phone, email or SMS about your request, including by local professionals who may handle it.

Call Now - 24/7 Dispatch