Bathroom remodeling
Kitchen remodeling
Home additions & ADU
Roofing
Windows & doors
Driveway & pavers
FenceFree written scope consultation - allowances, timeline, and change-order rules on paper before a single trade is scheduled
ES Windows Bathroom Remodeling: The Arlington Owner’s Guide
Bathroom remodeling built around ES Windows products in Arlington typically runs $9,000 – $28,000 installed, depending on whether you’re updating a full bath or reworking the layout behind the walls. We handle the whole job: tile, vanities, waterproofing, plumbing rough-in, permits, and inspections. Most Arlington bathrooms take two to four weeks from demo to final walkthrough.
Owners usually discover a problem the slow way. You notice a soft spot near the shower pan, or the caulk line at the window opening keeps reopening every few months. Sometimes it’s a fogged glass unit in a bathroom window or a vanity that’s sagging because the subfloor underneath has been damp for years. Bathroom failures rarely announce themselves. They show up as a stain on the ceiling below, a closet that smells faintly of mildew, or grout that cracks in the same spot every season. That’s your cue to get an honest look before the damage compounds.
Which ES Windows Models This Applies To
ES Windows has produced several series over the years, and the part you need depends on which one is in your Arlington home. Vinyl single-hung and double-hung units from their residential lines use lift rails, tilt latches, and balances that aren’t interchangeable across series. If your bathroom window is a fixed or awning configuration – common in half-baths and shower walls – the sash and glazing hardware are different again.
Find the label first. ES Windows units typically carry a manufacturing sticker on the interior jamb or the top of the sash, and it lists the series, size, and date of manufacture. If the sticker is gone, measure the visible glass and the frame opening at three points each and photograph the pivot bars, latches, and balance shoes. Those photos do more to identify the right part than any model number guess.
The OEM-versus-aftermarket call matters here. ES Windows still supports many of its residential series with original hardware, and when it’s available, that’s usually the right answer for a bathroom window where fit and finish are tight. Aftermarket equivalents exist for common tilt latches, weatherstrip, and balance assemblies, and they work well when the spec matches. Where they usually fail is in the balance spring tension – a slightly different rating will make the sash feel heavy or let it drop. Most homeowners should not be replacing balances themselves; that’s a spring under tension, and we’ll say so plainly below.
One more point: Barrett & Sons Construction Arlington is an independent remodeling and installation contractor. We are not affiliated with ES Windows, and we don’t sell their parts. What we do is work with the products already in your home and install material that matches the existing system.
Styles & brands we work with
- Kitchen remodeling
- Bathroom remodeling
- Home additions & ADU
- Roofing
- Windows & doors
- Driveway & pavers
- Fence
Signs Your ES Windows Bathroom Remodeling Is Failing
- Fogging between the panes. The seal on the insulated glass unit has failed, letting moisture in. In Arlington’s humidity swings, a failed seal shows up fast, usually within a season of the first crack.
- A sash that won’t stay up or drops on its own. The balance spring has lost tension or the shoe has worn. On bathroom windows this often goes unnoticed until someone gets a sash on the fingers.
- Water staining or soft drywall below the window or beside the shower. This is usually a failed seal at the frame or a waterproofing gap behind the tile, not the window itself. Both need to be checked before you re-caulk and move on.
- Grout or caulk that cracks in the same line every few months. Repeated cracking points to movement behind the substrate – often a subfloor or backer board issue in older Arlington bathrooms.
- A vanity that rocks or a toilet that rocks. That’s a subfloor problem, and it’s the most common reason a “simple” bathroom update turns into a full remodel once the floor comes up.
Replacement Cost & What’s Included
Bathroom remodeling in Arlington runs $9,000 – $28,000 installed. A small bathroom remodel is $5,000 – $12,000. A walk-in shower installation is $4,500 – $12,000. A tub-to-shower conversion is $3,500 – $10,000, and a shower replacement alone is $3,000 – $8,500. A bathroom vanity installation is $800 – $3,000, and if a window needs replacing while we’re in there, window replacement is $4,500 – $15,000.
What drives the range: whether the layout moves, how much plumbing and electrical has to be re-routed, tile selection and square footage, and whether the subfloor or waterproofing needs rebuilding. Every scope and allowance is written on the contract before work starts, and any change comes as a written change order before it touches the job. Every eligible job gets permits pulled and inspections signed. Every completed job carries our 90-Day Done Right Promise in writing.
See the difference
Before
After
Before
After
Before
AfterDIY or Call Us?
You can safely check a few things yourself. Look for the ES Windows label, photograph the window hardware, run a level across the vanity and toilet base, and press on the drywall around the shower for soft spots. That information helps us quote accurately.
Where DIY goes wrong is the balance assemblies and anything behind the tile. Window balances are springs under tension, and a slipping sash can snap back hard enough to cut a hand. Waterproofing behind a shower is a system – one skipped step and you’re tearing it out in two years. Same for subfloor repair: patch it wrong and the new tile cracks in a season. Call us at (888) 590-9867 for a free estimate; we’ll tell you honestly what needs doing and what can wait.
FAQs
Most residential windows should serve 15 to 20 years, though the insulated glass seal often fails sooner in North Texas heat – we see fogging well before the frame is done. Bathroom fixtures and tile last much longer if the waterproofing was done right the first time. Call (888) 590-9867 for a free estimate if yours are past that mark.
Sometimes, yes. A single balance, latch, or weatherstrip can often be replaced on its own if the rest of the window is sound. Fogged glass usually means replacing the insulated unit or the whole window. On the remodel side, a small vanity swap or tile repair is often enough. We’ll tell you which side of that line your job falls on.
A vanity or shower swap can finish in a few days; a full bathroom remodel typically runs two to four weeks in Arlington. Window replacement on a single unit is usually a half-day. We’ll put the schedule in writing with the contract.
We work with suppliers we’ve used for years and match the existing ES Windows system by series, size, and hardware spec. We don’t stock parts or carry them on a truck – we source what your specific unit needs. Ask us for the second opinion on any written estimate you’ve already got; it’s free.
We also work with KraftMaid, Cambria, and Silestone for the vanity and surface side of the job.
Get a Free Estimate in Arlington
If your ES Windows bathroom project needs an honest look, call Barrett & Sons Construction Arlington at (888) 590-9867. Our technicians have up to 28 years of experience, every eligible job gets permits pulled and inspections signed, and every completed job carries the written 90-Day Done Right Promise. We’ll give you a free estimate with scope and allowances on paper, and a second opinion on any other written estimate at no charge. Ask about the standing offers: $40 Off Any Repair Over $200, No Trip Charge Inside the County, and the permanent 10% Senior & Veteran discount.
Written by the team at Barrett & Sons Construction Arlington, serving Arlington and nearby areas.