A Barrett company - serving Arlington, TX
S

Sterling Driveway & Pavers in Arlington, TX

Driveway & paversDriveway & pavers
Kitchen remodelingKitchen remodeling
Bathroom remodelingBathroom remodeling
Home additions & ADUHome additions & ADU
RoofingRoofing
Windows & doorsWindows & doors
FenceFence
Every visit starts with

Free written scope consultation - allowances, timeline, and change-order rules on paper before a single trade is scheduled

We have financing partners for your dream remodel*On approved credit; ask us about your options
Get your free estimate

Sterling Driveway & Pavers: The Arlington Owner’s Guide

We install and replace Sterling-compatible driveway and paver systems across Arlington, and a full paver driveway here typically lands between $7,000 and $18,000 depending on square footage, base prep, and paver choice. This page is for owners whose Sterling driveway or paver surface has started to fail: settling, joint-sand loss, cracked units, or water pooling where it didn’t before. In Arlington’s clay-heavy soil, the failure is usually under the pavers, not in the pavers themselves – and that changes the whole repair conversation. We’re an independent installer, not affiliated with Sterling, and we’ll tell you plainly which Sterling components we can match and which have to be swapped for an equivalent.

Call (888) 590-9867

Key takeaways

  • Sterling paver driveways in Arlington run $7,000-$18,000 installed; repairs and resetting are priced separately.
  • Most “Sterling paver failures” are base failures caused by North Texas soil movement, not defective pavers.
  • Joint sand and edge restraint are the two cheapest things to fix early and the two most expensive to ignore.
  • We write the scope and every change order before work starts, and every eligible job gets permits pulled and inspections signed.

Which Sterling Models This Applies To

Sterling’s driveway line covers interlocking concrete pavers in several profiles and thickness classes, and matching a replacement unit means matching three things: the face profile, the nominal thickness, and the chamfer style. A 2 3/8-inch paver will not sit level against a 2 3/4-inch paver, and mixing the two in one field creates a rocking joint within a season. Pull a loose unit and measure it – thickness to the nearest 1/16 inch, face length and width, and note whether the edge chamfer is a simple bevel or a wider chamfered shoulder.

Look for the manufacturer stamp on the side of the unit; Sterling stamps their pavers, and the stamp plus your measurement gets you the right match faster than a photo will. On the OEM-versus-aftermarket question, here’s the honest version: for pavers, an equivalent-quality aftermarket unit in the same thickness and a close face profile is a legitimate replacement, and often the only practical one when a color run is discontinued. For edge restraint, base aggregate, and polymeric joint sand, aftermarket is normal and expected – these are commodity components. What you shouldn’t do is substitute a thinner paver to save a dollar. In Arlington, the base and the load spread do the work, and a thin unit fails first.

Explore

Styles & brands we work with

  • Kitchen remodeling
  • Bathroom remodeling
  • Home additions & ADU
  • Roofing
  • Windows & doors
  • Driveway & pavers
  • Fence

Signs Your Sterling Driveway & Pavers Is Failing

  • Pavers rocking or “walking” underfoot. The bedding layer has lost contact with the base, usually after a wet spring. Once a paver rocks, the joint sand drains out from under it and the problem spreads to its neighbors.
  • Joint sand washing out after storms. North Texas downpours push sand out of the joints when the edge restraint has loosened or the surface isn’t draining. Refilling without fixing the restraint just buys you a few months.
  • Depressions or dips in the field. This is base settlement, and in Arlington’s expansive clay it’s common along the driveway apron near the street where water concentrates. Depressions hold water, and standing water accelerates everything else.
  • Edge restraint heaving or separating. The edge is what holds the whole field tight. When it lifts, the outer course spreads, joints open, and the driveway starts to lose its shape from the outside in.
  • Cracked or spalled units at the street entrance. Vehicle loads plus freeze-thaw cycles spall the leading edge. A few cracked units are cosmetic; a cracked field usually points back to base or drainage.
Before & after

See the difference

Before - Recent ProjectBeforeAfter - Recent ProjectAfter
Recent Project
Before - Full RestorationBeforeAfter - Full RestorationAfter
Full Restoration
Before - Complete UpgradeBeforeAfter - Complete UpgradeAfter
Complete Upgrade

Replacement Cost & What’s Included

Here’s what driveway and paver work typically runs in Arlington, installed:

  • Paver driveway installation (full replacement): $7,000-$18,000
  • Concrete driveway installation: $4,500-$12,000
  • Driveway replacement (pavers over new base): $5,000-$14,000
  • Driveway sealing: $250-$700
  • Paver patio installation: $3,500-$11,000

What drives the range: total square footage, how much base has to come out and be re-compacted, whether the edge restraint gets rebuilt, and the paver line you choose. A reset-and-re-sand job where the base is sound sits at the low end; a full tear-out with new aggregate base at proper depth sits at the top. We quote parts and labor as separate lines so you can see exactly what you’re paying for, and any change to scope arrives as a written change order before we touch the driveway. Completed work is backed by the written 90-Day Done Right Promise – if something isn’t right, one call brings Tom back.

DIY or Call Us?

You can safely check a few things yourself: pull one loose paver and measure it, sweep the joints to see how deep the sand loss goes, and watch where water stands after a hard rain. That’s information, not repair. Where DIY goes wrong is the base. Re-laying pavers over an unaddressed settlement or a failed edge restraint looks fine for a month and then opens up again, and by then you’ve paid twice. Tear-out and re-compaction of a driveway base is real physical work with compaction equipment and proper drainage slope – it’s not a weekend wheelbarrow job, and a bad base is worse than no base. If the pavers are only rocking in one small area, call us and we’ll tell you honestly whether a spot repair makes sense or whether you’re throwing money at a symptom.

Call (888) 590-9867 to schedule a free estimate – a live person answers, day or night, and there’s no trip charge inside the county. We also work with KraftMaid, Cambria, and Silestone on the interior side if a driveway project turns into a larger whole-home conversation.

FAQs

Need Construction help nationwide? Licensed & insured · free written estimates
Call (888) 590-9867
Local Service Coverage

Request a Free Estimate in Arlington

Tell us what you need - Barrett & Sons Construction Arlington responds fast. No obligation.

By submitting this form you agree to our Privacy Policy and consent to be contacted by phone, email or SMS about your request, including by local professionals who may handle it.

Call Now - 24/7 Dispatch