A Barrett company - serving Arlington, TX

Tamko Driveway & Pavers in Arlington, TX

Driveway & paversDriveway & pavers
Kitchen remodelingKitchen remodeling
Bathroom remodelingBathroom remodeling
Home additions & ADUHome additions & ADU
RoofingRoofing
Windows & doorsWindows & doors
FenceFence
Every visit starts with

Free written scope consultation - allowances, timeline, and change-order rules on paper before a single trade is scheduled

We have financing partners for your dream remodel*On approved credit; ask us about your options
Get your free estimate

Tamko Driveway & Pavers: The Arlington Owner’s Guide

Tamko driveway and paver work in Arlington usually runs $7,000 – $18,000 for a full paver driveway, with smaller sections and patios in the $3,500 – $11,000 range; we install Tamko-compatible products and can typically schedule a free estimate within a few days, though the work itself is planned, not same-day. Barrett & Sons Construction Arlington is an independent contractor, not affiliated with Tamko.

Call (888) 590-9867

Owners almost always discover the problem the same way: a hairline crack that widens after a freeze, a paver that rocks when the mower rolls over it, or a low spot that holds water two days after rain. In Arlington, the clay soil underneath is the real story – it swells when wet and shrinks when dry, and it moves whatever sits on top of it. That movement shows up in the pavers long before it shows up anywhere else on your property.

Which Tamko Models This Applies To

Tamko makes a few different paver and hardscape lines, and the right replacement depends on which one you have. The most reliable way to identify yours is to pull the spec sheet from the original installation (ask the builder or check the closing packet if the home was new) or read the stamp on the underside of a loose paver – most Tamko pavers carry a mold mark with the profile name. Measure one paver’s length, width, and thickness to the sixteenth of an inch; a half-inch mismatch on thickness is the most common compatibility gotcha, and it’s why a “close enough” paver from a different line will rock and telegraph through the surface within a season.

For the OEM-versus-aftermarket call: if you have a partial pallet or the original color still matches, an exact Tamko replacement is worth the wait. If not, a quality aftermarket paver matched to the same compressive strength and absorption rating will hold up fine – the base preparation matters more than the brand on the face. We don’t keep Tamko stock on hand, so we source to your specific profile and color rather than pulling whatever’s closest off a shelf.

Explore

Styles & brands we work with

  • Kitchen remodeling
  • Bathroom remodeling
  • Home additions & ADU
  • Roofing
  • Windows & doors
  • Driveway & pavers
  • Fence

Signs Your Tamko Driveway & Pavers Is Failing

  • Paver edges chipping or spalling. Usually freeze-thaw damage combined with a base that couldn’t drain; water gets into the joint sand, freezes overnight, and pops the surface. Arlington sees enough hard freezes in January and February to do this to a poorly drained drive.
  • Rutting or settling in wheel paths. The sub-base wasn’t compacted deep enough, or the clay underneath is shifting. Once a rut forms it catches water, and that water speeds up the failure.
  • Joint sand washing out. Failed polymeric sand or a slope that sends runoff across the pavers instead of off the edge. Left alone, loose pavers follow.
  • Rocking or uneven pavers. A sure sign of base failure or a broken edge restraint, not just a single bad stone.
  • Weeds or moss in the joints. Small issue on its own, but combined with any of the above it tells you the joint sand is gone and water is sitting where it shouldn’t.
Before & after

See the difference

Before - Recent ProjectBeforeAfter - Recent ProjectAfter
Recent Project
Before - Full RestorationBeforeAfter - Full RestorationAfter
Full Restoration
Before - Complete UpgradeBeforeAfter - Complete UpgradeAfter
Complete Upgrade

Replacement Cost & What’s Included

Here’s what Arlington homeowners should expect to see in a written, line-item estimate:

Scope Typical Installed Range
Paver driveway installation (full) $7,000 – $18,000
Paver patio installation $3,500 – $11,000
Driveway replacement $5,000 – $14,000
Driveway sealing (maintenance) $250 – $700

What drives the range: square footage, whether the old surface and base have to come out, how deep the base needs to go on your particular soil, and which paver line and color you choose. Parts and labor are itemized separately so you can see what the material actually costs. Every job comes with permits pulled where eligible and the 90-Day Done Right Promise in writing – if something isn’t right, one call brings Tom back.

DIY or Call Us?

What you can safely check: pull up one loose paver and look at the base underneath, check whether joint sand is missing across the whole drive or just one area, and look at where the water runs when it rains. That’s diagnostic, not repair.

Where DIY goes wrong on pavers is the base. The compaction, drainage slope, and edge restraint are the parts nobody sees and the parts that fail first. If the base is wrong, the nicest paver laid on top will settle within a season. And once you’re pulling up a section, it’s not a weekend job for most folks. Our technicians have up to 28 years of experience on this exact work. Call (888) 590-9867 and we’ll take a look before you buy a single paver.

FAQs

Need Construction help nationwide? Licensed & insured · free written estimates
Call (888) 590-9867
Local Service Coverage

Request a Free Estimate in Arlington

Tell us what you need - Barrett & Sons Construction Arlington responds fast. No obligation.

By submitting this form you agree to our Privacy Policy and consent to be contacted by phone, email or SMS about your request, including by local professionals who may handle it.

Call Now - 24/7 Dispatch