Home additions & ADU
Kitchen remodeling
Bathroom remodeling
Roofing
Windows & doors
Driveway & pavers
FenceFree written scope consultation - allowances, timeline, and change-order rules on paper before a single trade is scheduled
Tamko Home Additions & ADU: The Arlington Owner’s Guide
We build and finish Tamko-compatible home additions and ADUs in Arlington, and most completed projects land between $45,000 and $130,000 depending on size, foundation, and finish level. ADU construction runs $90,000 to $220,000; garage conversions sit at $30,000 to $80,000. This isn’t a quick-swap part page, and we want to be straight with you about that. What you’re usually discovering when you land here is a failed chimney flashing, a shingle-tab blowoff at the addition tie-in, or a flashing leak where the new roofline meets the old one, and it’s showing up as a ceiling stain or a soft spot in the drywall.
We’re an independent contractor and not affiliated with Tamko. We install and repair the materials and we stand behind the work with our 90-Day Done Right Promise in writing.
Key Takeaways
- Additions in Arlington: $45,000 to $130,000 installed.
- ADUs: $90,000 to $220,000. Garage conversions: $30,000 to $80,000.
- Every eligible job pulls permits and gets inspections signed off.
- If a flashing failure caused the damage, we diagnose it before we quote.
- We answer the phone live, 24/7. Call (888) 590-9867.
Which Tamko Models This Applies To
Tamko makes roofing and waterproofing products, not framing or finish. So when we say “Tamko home additions and ADU,” we’re talking about the Tamko shingles, underlayments, and flashing components that cap the addition you build. That distinction matters for how we spec a project. The common Tamko lines you’ll find on Arlington additions are Heritage and Heritage Premium, which are the standard architectural shingle for residential re-roofs and additions. If you’re reading a bundle label, look for the series name, the warranty registration card, and a coverage spec in squares. Heritage is a 30-year limited warranty shingle; Heritage Premium steps that up. The old three-tab Tamko lines are still on plenty of pre-2000s homes in Arlington, and if that’s what’s up there, mismatched patches will show.
On OEM versus aftermarket: for the shingle itself, we won’t substitute an off-brand against a Tamko match because the color and granule blend won’t line up on a visible roofline. We’ll source OEM. On underlayment and drip edge, a quality aftermarket equivalent is fine and usually cheaper, and we’ll tell you which is which in the written scope. If you’re trying to match existing shingles, the only reliable check is a physical sample. Color names drift over the years even within the same line. Our technicians have up to 28 years of experience reading that match. Call (888) 590-9867 before you order anything.
Styles & brands we work with
- Kitchen remodeling
- Bathroom remodeling
- Home additions & ADU
- Roofing
- Windows & doors
- Driveway & pavers
- Fence
Signs Your Tamko Home Additions & ADU Is Failing
Here are the symptoms we see most often on Arlington additions, and what each one actually means.
- Granule loss in the gutter. That grit is your shingle’s UV protection washing off. On a Texas sun-exposed south slope, granules can go fast; once the mat is exposed, the shingle is on borrowed time.
- Dark streaks and staining on the roof plane. That’s usually blue-green algae feeding on limestone fillers, and it’s cosmetic early on but can look like a failure. On a north slope it can linger for years.
- Curling or clawing tabs. Shingles lift at the edges when attic ventilation is inadequate or when poor nailing has let the mat loose. On an addition the ventilated area changed, and the roof may not have been re-spec’d for it.
- Water staining at the addition tie-in. Where a new roofline meets the old one, flashing is the weak point. A drip trail on your ceiling is almost always the flashing and not the shingle.
- Lifted or missing flashing at chimney and valleys. Failed sealant, wrong step-flashing size, or ice-and-water underlayment missing at the eaves will cause this. In Arlington the freeze cycles are few but they’re real, and a bad flashing joint fails when the water backs up.
If you’re seeing two or more of these on the same slope, that roof isn’t patching out cheaply. It’s a re-roof conversation.
See the difference
Before
After
Before
After
Before
AfterReplacement Cost & What’s Included
Here’s what we quote for Arlington, installed. Full home addition: $45,000 to $130,000. ADU construction: $90,000 to $220,000. Garage conversion: $30,000 to $80,000. The lead driver of that spread is square footage, foundation, and whether the roofline ties into a Tamko-spec’d plane or a fresh one. Wiring, plumbing, permits, and rough-in finish drive it further.
| Project type | Installed range (Arlington) |
|---|---|
| Home addition | $45,000 – $130,000 |
| ADU construction | $90,000 – $220,000 |
| Garage conversion | $30,000 – $80,000 |
Every scope, every allowance, and every change order is in writing before work happens. That’s how we avoid the surprise invoice. We pull the permits and get the inspections signed on every eligible job.
DIY or Call Us?
Here’s the honest split. You can check for a leak by looking at the ceiling, feeling for spongy drywall, and reading the shingle tag in the attic. You can’t re-flash a tie-in or re-nail a course correctly without getting on the roof. Working at height on a steep slope is where DIY goes wrong fastest, and a bad flashing joint under a new addition will leak for years before you see the stain. Roofing and structural work are not a place for a homeowner with a ladder and a Sunday afternoon.
Our crews pull permits and inspect the flashings before closing the walls. We don’t leave a roof open over a weekend. Call us at (888) 590-9867 and we’ll look at it with you. Free second opinion on any written estimate you’ve already got. Estimates are free.
FAQs
How long does a Tamko shingle system on a Texas addition actually last? Realistically 20 to 30 years here, less on a full sun south slope. Arlington’s summers and occasional freeze cycles wear the mat faster than the warranty book suggests, which is why ventilation and flashing quality matter more than the shingle spec sheet.
Can the roof be repaired instead of replaced? Yes, if the damage is localized to one plane and the flashing failure isn’t structural. Two or more failing slopes means it’s re-roof time. We’ll tell you straight which one it is. Call (888) 590-9867 for a free estimate.
How long does the swap take? A full re-roof on an addition is usually a few days once permits are pulled and materials are on site. The addition itself is weeks to months depending on scope. We’ll give you a written schedule before we start.
How do you source the Tamko materials? Through supplier channels, OEM for the shingle and matching flashing. We confirm the series and color against a physical sample before ordering. We don’t carry stock on a truck, so nothing gets swapped on-site. Call (888) 590-9867 with your written scope and we’ll walk it with you. We also install KraftMaid, Cambria, and Silestone finishes on the interior side.
Call Barrett & Sons Construction Arlington at (888) 590-9867 for your free estimate. Written scope, written change orders, permits pulled, and the owner’s sons on the job. Ask anyone on your street, or look up the license yourself before you sign anything.
Written by the team at Barrett & Sons Construction Arlington, serving Arlington and nearby areas.